Sony Repair Tips
Search: sony
Results: 20073
Results: 20073
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SONY |
SPP320
|
No ring/no dial tone/line light goes out after a few seconds | No ring, no dial tone. line light goes out after a few seconds. relay wouldn't engage q-608 was good, but was not driving relay. | ||
SONY |
KV32XBR65
|
Ic-101 does not match part number in manual, see sb 92 | Above part number does not match with the part called for inthe service manual. -hq comments: during production, the microprocessor was changed.these two ic are not interchangable. please check to see what micro isbeing used before ordering from kcp. | ||
SONY |
DTC700
|
Audible click when using record pause | Sony sales in brisbane, ca has received complaints of anaudible click when using record pause. -hq comments: i checked a dtc-700 and a tcd-d3 in the lab with adigital and analog input. the tcd-d3 did not have a problem in eithermodes. i tried several | ||
SONY |
D66
|
Intermittent power | The force needed to connect and disconnect the ac adaptorbreaks the connection to the power jack on main pcb. | ||
SONY |
TAE1000ESD
|
No video output | Video 2 input works, but others do not. 2. audio works fine. | ||
SONY |
STRAV900
|
Discrepancy in the value of f-801 and f-802 | Unit came in with q-766 and q-765 shorted from c-e. f-801 andf-802 were also blown. the service manual parts list shows f-801 for(av900) this model as a 6.3 amp fuse while the unit itself has a label for8 amp fuses. the blown fuses were of the 8 amp v | ||
SONY |
CDP508ESD
|
Tray rattles as it comes out of the unit | When the open/close button is pushed, the tray would rattle asit was coming out and also when closing. | ||
SONY |
CCDTR4
|
Eating tapes | The tapes are being eaten. | ||
SONY |
CCDF55
|
Screen data jittering | The screen data is jittering. | ||
SONY |
CCDTR6
|
Iris is always open | Iris is always open. | ||
SONY |
CCDTR4
|
Incorrect part number | |||
SONY |
CDXR77
|
Display illumination is weak | Illumination is really weak and/or remote line out doesn't work. this problem occurs quite frequently. | ||
SONY |
CDXR79
|
Display illumination is weak | Illumination is really weak and/or remote line out doesn't work. this problem occurs quite frequently. | ||
SONY |
KV27XBR60
|
Dead set, cold solder joint r-167 | Dead set. the set could be turned on with remote but it cameon with channel 0 in display and picture was out of horizontal sync.once these evr adjustments were made, the set worked ok as long as itwas turned on or off with remote or by unplugging and re | ||
SONY |
KV27TS22
|
No video, replace ic-301 | Had no video, traced problem to defective ic-301. | ||
SONY |
CCDTR7
|
Incorrect part number ic141 | Incorrect part number in service manual. | ||
SONY |
DTC75ES
|
Crinkles tape | When unit is put into review mode, the tape skews downwardand is creased. the problem was found by gary kilbourne. what happens isthe pad that is attached to the lever assembly comes loose, providing noback tension. we have two new units with this prob | ||
SONY |
CDP990
|
Won't read or play discs - no toc | Intermittently reads or plays certain discs or none at all.during play unit skips consistently every few seconds and won't tracksearch properly. | ||
SONY |
KV27TR10
|
Dark picture, replace r-587 | Dark picture. g2 voltage less than +200vdc. no + 1000vdcsupply. | ||
SONY |
ITD150
|
Receiver audio fades out | After a time between 30 minutes and one hour, the receiveaudio in handset would fade out. doing almost anything to phone -pressing any button or going to on-hook and then off again would restorereceive audio for another hour. |