Sony Repair Tips
Search: sony
Results: 20100
Results: 20100
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
D4
|
Reference number is incorrectly listed | The part number for reference 904 is not listed in theservice manual. -hq comments: reference 904 should be listed as reference 903. refer-ence 903 should be 902. thank you for bringing this to our attention.a service bulletin has been written with th | ||
| SONY |
KV20TS20
|
Antenna, see flash 43, 1-501-372-41 | Is the antenna supplied with the set or not? also the an-18eis too big to fit into the hole in the back of the set. | ||
| SONY |
ECM909
|
Parts replacement for microphone | Inserting microphone into holder is very difficult, or themicrophone grip may be scratched. due to a molding defect, the holderscrew projects inside the holder and catches the grip as the microphone isinserted. | ||
| SONY |
CCDV3
|
No rew, viewfinder broken | Unit would start to rewind but shutdown in 2.3 seconds. | ||
| SONY |
RMX5
|
What is replacement remote for this unit | Customer is looking for a remote for his xtv-5 tuner. theunit came with a rm-x5 but this came up no longer available. can you tellme which remote will work as a replacement? -hq comments: this remote was a very simple remote. it just had ch,vol, pix, | ||
| SONY |
XTV5
|
What is replacement remote for this unit | Customer is looking for a remote for his xtv-5 tuner. theunit came with a rm-x5 but this came up no longer available. can you tellme which remote will work as a replacement? -hq comments: this remote was a very simple remote. it just had ch,vol, pix, | ||
| SONY |
PVM1910
|
Cannot adjust h size | H size is too wide. i cannot adjust h size. dc voltage dis-appears on q-801 collector. | ||
| SONY |
KV25DXR
|
Damaged c-570 on (d) board (jail bar - on left side screen | Jail bar appears on the left side of screen. | ||
| SONY |
KV2073R
|
Tuner drift | Tuner drift (very intermittent). on some cable systems ibelieve our tuners are being confused by the sheer amount of signals andthe + and - mixing products are causing our tuner/synthesizers to drift toadjacent channels. | ||
| SONY |
KV27DS1
|
Tuner drift, troubleshooting suggestion | Tuner drift (very intermittent). on some cable systems ibelieve our tuners are being confused by the sheer amount of signals andthe + and - mixing products are causing our tuner/synthesizers to drift toadjacent channels. | ||
| SONY |
SLHF1000
|
No operation (dead) | The 9v and 12v from ic-002 were missing. found c-024 (47uf)at pin 15 shorted. | ||
| SONY |
SL2710
|
Drum motor not running | Conductive glue on hall device. as it got older and harder,it was not allowing the hall device to conduct. | ||
| SONY |
SL2700
|
Drum motor not running | Conductive glue on hall device. as it got older and harder,it was not allowing the hall device to conduct. | ||
| SONY |
SL2500
|
Drum motor not running | Conductive glue on hall device. as it got older and harder,it was not allowing the hall device to conduct. | ||
| SONY |
SL2400
|
Drum motor not running | Conductive glue on hall device. as it got older and harder,it was not allowing the hall device to conduct. | ||
| SONY |
KV2649RX
|
Antenna change switch | This part is no longer available. what do we use as asubstitute for this part?-hq comments: please see service bulletin number 61. | ||
| SONY |
FD500
|
Part number for charcoal gray knobs missing | There are no part numbers listed in the service manual for thecharcoal gray knobs. | ||
| SONY |
KV1953R
|
D-510 lead was too short | D-510 lead was too short. not through pc board. | ||
| SONY |
SLHF450
|
Not beta hi-fi | No beta hi-fi or beta hi-fi light. regular audio is ok. wehave three reports of this. | ||
| SONY |
PBR330
|
Part number needed | I need the part number for the microphone holder that goeswith a pbr330 parabolic reflector. -hq comments: the following part numbers must be ordered: 2-212-424-00,2-212-425-00 and 2-212-426-00. please note that since this is not a u.s.product there wi |