Sony Repair Tips
Search: sony
Results: 20072
Results: 20072
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
XE-3
|
Tuner drift aft 4 mins then chan search | Switches s401-413 on front panel faulty | ||
| SONY |
XE3
|
Takes a long time to come on. | Ra'a' (A.M.) A/S. | ||
| SONY |
XE3
|
Standby - stuck in standby. | R632 ( 2.2m ) going high on panel a. | ||
| SONY |
XE3
|
No s/v , main supplies all coect | Check 12v supply to tuner , follows complex path via r811 , d811 , connector d5 , and a12 pin 1 , q207 | ||
| SONY |
XE3
|
Int startup. | Rt01 (A.F.), Rt08 (D.M.), Rt09 (A.M) | ||
| SONY |
XE3
|
Flyback lines - picture shaded with no signal | C801 leaky. | ||
| SONY |
XE3
|
Flyback - lines - intermittent. | D304. | ||
| SONY |
XE3
|
Dead. | Yasat 01 (Webs 1394S), Ra’a’ (A.M), Qa’ 02 (refute) | ||
| SONY |
XE3
|
Dead. | R632 ( 2.2mr ) going high on panel a. | ||
| SONY |
XE3
|
Dead with no drive at pin 7 of the chopper control | R632 ( 2.2m ) , which is connected to pin 4 of ic601 and is used for standby switching. | ||
| SONY |
XE3
|
Dead , ic oscillating ( may start if ic heated ) | R 602 , 2.2m 1/2 w | ||
| SONY |
XE3
|
Blank screen sound ok | Upc1377 line osc ic faulty | ||
| SONY |
XE2
|
Tuner out of action | If 33v ok check q10 for control voltage vc point on tuner if low replace c134 inside tuner | ||
| SONY |
XE2
|
Startup - no or intermittent - fuse intact | Ic601. | ||
| SONY |
XE2
|
Slow startup. | R602 goes high. | ||
| SONY |
XE2
|
No startup. | R602 ( 2.2mr ) o/c , ic601 ( upc1394c ) | ||
| SONY |
XE2
|
Dead. | R602 ( 2.2mr ) o/c. | ||
| SONY |
XE2
|
Dead - after 5-10 seconds at sw on | R602 high or o/c. | ||
| SONY |
XE2
|
Dead - pin 4 of chopper ic not 2.9v. | R602 2m2 o/c. | ||
| SONY |
VTX-100CS TV TUNER
|
No sound | Check/replace r358 220Ω resistor |