Toshiba Repair Tips
Search: toshiba
Results: 5591
Results: 5591
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| TOSHIBA |
2500TB
|
Picture visible for few secs with scan fault then | R448 2.7Ω high toshiba 4984279 ( 12v to taa8659an falls to about 8v ) | ||
| TOSHIBA |
2500TB
|
Int clock stops on teletext | Resolder xtal xf01 13.875 on u101 text board | ||
| TOSHIBA |
2500TB
|
If chopper tr sc check r810 330k out of cct | Ht should be set for 145v | ||
| TOSHIBA |
2500TB
|
Field lin | C303 2µ2 50v in field drive near pin 32 ta8659 | ||
| TOSHIBA |
2500TB
|
Field - top of pic stretched | C303 2µ2 o/c | ||
| TOSHIBA |
2500TB
|
Dead int - esp when chassis slid in & out | Check resistor not touching audio o/p chip heatsink | ||
| TOSHIBA |
2500TB
|
Chopper transistor sc | Check r810 330k | ||
| TOSHIBA |
2500DBT
|
Poor field lin | C317 2µ2 next to fop chip heatsink | ||
| TOSHIBA |
221T3B
|
Field top foldover - ok when warm. | C312 ( 10uf , 35v ) | ||
| TOSHIBA |
221E
|
Frame top foldover. | C313. | ||
| TOSHIBA |
21T4B
|
Frame collapse - may be intermittent. | C312 int s/c. | ||
| TOSHIBA |
21S04B
|
Dead set with led blinking | Fd802 630ma fuse o/c & shorted turns loptx t444 pt no az363004 | ||
| TOSHIBA |
219X9M
|
Severe foldover bottom frame low height | Replace c303 1mfd 63v | ||
| TOSHIBA |
219T9B
|
Whine only | D601 s/c on 12v rail | ||
| TOSHIBA |
219T9B
|
Ht does not get above 90v | Replace c814 100mfd50v | ||
| TOSHIBA |
219T9B
|
Dead no 5v on connector p587 pin 6 | R843 15r oc | ||
| TOSHIBA |
219T9B
|
Dead , ic801 str54041 inactive check for 5v at pin | R483o/c safety resistor | ||
| TOSHIBA |
219T9
|
Dead str54041 sc | Check q802 base emitter as if sc - str will blow again .check out of cct | ||
| TOSHIBA |
218D9B
|
No pic - blank raster when a1 advanced - sound ok | No scastle pulse pin 35 ta8659n - c410 2700pf dry joint (under plastic frame by loptx) | ||
| TOSHIBA |
218D9B
|
Field lin stretched at top | C317 2µ 50v, c308 2µ2 50v - little red caps near fop chip |