Grundig Repair Tips
Search: Grundig
Results: 948
Results: 948
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| GRUNDIG |
CUC2410
|
Agc fault - dist pic on good signal | Video discriminator coil on if f2211 | ||
| GRUNDIG |
CUC2401
|
Trips at sw on | L519 shorted turns | ||
| GRUNDIG |
CUC2401
|
Tripping - at switch on. | R637 1k control. | ||
| GRUNDIG |
CUC2401
|
Tripping - at switch on - may come on. | C661 ( 7u f , 25v ) | ||
| GRUNDIG |
CUC2401
|
Switching to standby - my take days. | Triple. | ||
| GRUNDIG |
CUC2401
|
Startup - failure to start intermittent. | Set ht r637 ( 1k ) may ch ok , loptx if going off af few mins | ||
| GRUNDIG |
CUC2401
|
Standby - intermittent shut down. | Set ht control r637 ( 1k ) may check ok. | ||
| GRUNDIG |
CUC2401
|
Sound - mutes on video rec playback. | Mod abl module. | ||
| GRUNDIG |
CUC2401
|
Set goes to stby very int | Tripler us | ||
| GRUNDIG |
CUC2401
|
No sound or - picture - intermittent. | Suspect the set-eht control ( especially if made by preh. | ||
| GRUNDIG |
CUC2401
|
No sound | Could be tda2595, tda130 or sda2011-a003 micro | ||
| GRUNDIG |
CUC2401
|
No sound | Tba130 chip not working due to c2276 470µ s/c | ||
| GRUNDIG |
CUC2401
|
No sound | C2276 ( 470uf ) s/c. | ||
| GRUNDIG |
CUC2401
|
No raster - line collapse | Loptx o/c | ||
| GRUNDIG |
CUC2401
|
No picture - sound ok | No vid o/p pin 8 tda3566 - tr2523 bc548c s/c | ||
| GRUNDIG |
CUC2401
|
No pic - blanked out | Field only half normal height due to supply only 10v to field chip - r525 0r33 hi res | ||
| GRUNDIG |
CUC2401
|
Low controllable sound | Tuner | ||
| GRUNDIG |
CUC2401
|
Int switches to st/by | Triple | ||
| GRUNDIG |
CUC2401
|
Int start up | Tda4600 chopper chip | ||
| GRUNDIG |
CUC2401
|
Int loss of pic caused by field collapse | 26v supply pin 8 tda2655b was only 4v - d2758 by298 & c2758 1000µ replaced |