☰

Beko Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: beko
Results: 235
Make Model Symptom Problem Solution By
BEKO KX1.190
KX1.190 		Dark image with very strong colors on one side Low voltages on the collectors of the RGB and G2 transistors seem to indicate kinescope. Remove ceramic bonded to g2, c714. this cond. Ceramic only leaks under load, measuring outside the circuit is fine. This problem may appear on TVs from other brands electronico
BEKO E1
E1 		TV turns on, tsound is no mat C630 - 220mf/16v seco MATA
BEKO NR30WLB500S
L4B 		No pictures sound ok, back light can see for 1,2 second Faulty one of high voltage transformers (4006a4250037) John Doe
BEKO 12.6
12.6 		The LED turns on and makes a buzzing sound but the voltages are low Replace altered 0.1r r615 resistance. jose almeida tavares
BEKO 28B8T47
14.2 		Dead Optical coupler ;-) Nezocas
BEKO PLAYSONIC 14.1
14.1 		Does not start, power supply voltages ok, tsound is no ht. R503 (47r) open faroltek
BEKOTEKNIK COLOR TV59D
N/T 		O/w of No modulo 0/w ic1101 (tda8145) Test the diodes J.CUNHA
BEKO 12.1
12.1 		Inoperativa, led pisca Substituir c914 por 4.7 uf/50v.
BEKO 14.2
14.2 		Mono, pip versions are not available in the manual Please see the soft copy on the web page Mário Tavares
BEKO 14.2
14.2 		Replacing termal brand fbt with eldor Please apply tcn 2002/13 Mário Tavares
BEKO 14.2
14.2 		Vertical defects :ic501 (tda8359j) and r522 (fuse resistor) Please apply tcn 2002/14 Mário Tavares
BEKO 14.2
14.2 		Subwoofer sound is not good, sometimes distorted Check 1nf on position c361 which is parallel to the speaker Mário Tavares
BEKO 14.2
14.2 		Sound is distorted during start up Check c350 capacitor Mário Tavares
BEKO 14.2 
14.2  		Spot on the cpt during shut off Please check if c704 on crt module is short circuited Mário Tavares
BEKO 14.2 
14.2  		Sound is distorted Check and replace c112 Mário Tavares
BEKO 14.2 
14.2  		No horizontal sync Check and replace ic101 Mário Tavares
BEKO 14.2 
14.2  		Tsound is a bad noise at some channels Check and replace ic101 Mário Tavares
BEKO 14.2 
14.2  		Some channels are absent Replace r129 with 2.5kΩ potentiometer and change the value of c143 as 47n Mário Tavares
BEKO 14.2 
14.2  		Microprocessor spare parts codes in the service manual are not correct Please see tcn's 2003/10, 2003/08 and 2002/17 Mário Tavares
BEKO 14.2 
14.2  		Sometimes flyback lines Replace 220r 1/4w r709 with a stronger one (example 101223). Mário Tavares