Beko Repair Tips
Search: beko
Results: 235
Results: 235
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| BEKO |
30328T
|
White line down centre of screen top to bottom} | Replace c805 | ||
| BEKO |
12,8
|
Red or green or blue screen | Check and replace on crt module : d702, d703, d704 all 1n4148 replace with type 1n4948t | ||
| BEKO |
12,8
|
No audio | Check and replace ic101 with stv2246c and check and replace c135 100uf, 16v replace it with a 220uf, 50v. also check and replace c308 470uf, 16v replace it with a 470uf, 50v | ||
| BEKO |
12,8
|
The +ub voltage +118v was not present, fault in switching power supply | Transistor t901 sk2545 or p3nb60fp had failed. replace it and check c908 22uf, 35v replace it with 22uf, 50v. also c912 1uf, 25v replace it with 1uf, 50v and d906 1n4148 always replace it with 1n4948t | ||
| BEKO |
14,2
|
The +ub voltage +140v was not present, fault in switching power supply | Transistor t601 sk2545 had failed, replace/check resistor r602 1megΩ in switch control circuit, also if t601 is s/c the control chip tda16846 will also be damaged | ||
| BEKO |
KX1.190
KX1.190 |
Dark image with very strong colors on one side | Low voltages on the collectors of the RGB and G2 transistors seem to indicate kinescope. | Remove ceramic bonded to g2, c714. this cond. Ceramic only leaks under load, measuring outside the circuit is fine. This problem may appear on TVs from other brands | electronico |
| BEKO |
E1
E1 |
TV turns on, there is no mat | C630 - 220mf/16v seco | MATA | |
| BEKO |
NR30WLB500S
L4B |
No pictures sound ok, back light can see for 1,2 second | Faulty one of high voltage transformers (4006a4250037) | John Doe | |
| BEKO |
12.6
12.6 |
The LED turns on and makes a buzzing sound but the voltages are low | Replace altered 0.1r r615 resistance. | jose almeida tavares | |
| BEKO |
28B8T47
14.2 |
Dead | Optical coupler | ;-) | Nezocas |
| BEKO |
PLAYSONIC 14.1
14.1 |
Does not start, power supply voltages ok, there is no ht. | R503 (47r) open | faroltek | |
| BEKOTEKNIK |
COLOR TV59D
N/T |
O/w of | No modulo 0/w ic1101 (tda8145) | Test the diodes | J.CUNHA |
| BEKO |
12.1
12.1 |
Inoperativa, led pisca | Substituir c914 por 4.7 uf/50v. | ||
| BEKO |
14.2
14.2 |
Mono, pip versions are not available in the manual | Please see the soft copy on the web page | Mário Tavares | |
| BEKO |
14.2
14.2 |
Replacing termal brand fbt with eldor | Please apply tcn 2002/13 | Mário Tavares | |
| BEKO |
14.2
14.2 |
Vertical defects :ic501 (tda8359j) and r522 (fuse resistor) | Please apply tcn 2002/14 | Mário Tavares | |
| BEKO |
14.2
14.2 |
Subwoofer sound is not good, sometimes distorted | Check 1nf on position c361 which is parallel to the speaker | Mário Tavares | |
| BEKO |
14.2
14.2 |
Sound is distorted during start up | Check c350 capacitor | Mário Tavares | |
| BEKO |
14.2
14.2 |
Spot on the cpt during shut off | Please check if c704 on crt module is short circuited | Mário Tavares | |
| BEKO |
14.2
14.2 |
Sound is distorted | Check and replace c112 | Mário Tavares |