Cce Repair Tips
Search: cce
Results: 4824
Results: 4824
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| CCE |
TV29USP
|
Distorted image with dark band on the right side. | Vertical o ic 301 stv 8179f | Replace for the same or equivalent. | Edigar de Souza Moulaz |
| CCE |
HPS 2001
|
Washed canvas | Vertical ci IC 301-TDA9309 and FR402 and 403 of 1Ω. | samuel leite | |
| CCE |
HPS2171FS
|
LED flashes, tries to turn on and goes to stand by | Without +b9 and +b8v | Dz 606 shorted (8v2) | jasvan souza |
| CCE |
TV2118USP
|
Interference in the image serrated and reduced left side | Cap. c417 331/2kv | infoaçu eletronica | |
| SOM CCE |
MD 3032
|
Doesn't start | Transformer defect | After the replace it started working again | |
| CCE |
HPS3407
|
TV turned on and off | Capacitor eletrolitico de 100mf/160vlts | Just replace it and you're good to go again | plramos |
| CCE |
TV-2918USP
|
Turning off before the image appears | I got the tip from my electronics friend Arthur from hps2071. who says that to know wsound the def is, remove the two protection trans. in my case q404 and q405, if it works normally, take a look at this line | In my case it was open q404. Here's a tip for this entire line that uses this protection. | antonio nobrega(patos pb) |
| CCE |
TV2118
|
Try to turn it on, the LED blinks and returns to horizontal stanby, heating up a lot | Short fly back | After removing the deflector connectors, the fly back smoked, just replaced it. | BETO ELETRONICA ACRELANDIA ACRE |
| CCE |
HPS 2985
|
Relay arms and disarms power supply 8.v | R824 3r9 amended | E.MATOS | |
| CCE |
HPS 1480
|
Contrast does not work. | D 290 e 704. | Replace the same. | BARRETO CRUZ |
| CCE |
HPS 1465
|
Does not tune channels. | The - 7910 | Replace the same. | BARRETO CRUZ |
| CCE |
HPS 1471
|
Escaping image and sound | R - 109 (12k) | Replace the same. | BARRETO CRUZ |
| CCE |
HPS - 2985
|
No brightness and no sound | Capacitor de 330pf/2kv. proximo ao tsh. | Replace the same. | BARRETO CRUZ |
| CCE |
HPS3407
|
It turns on normally but the image has oscillating colors with trace lines in the background | The cause was on the abl line, I changed the r441 and it was resolved | Replace r441 thanks guys | luis carlos de bel foxo |
| CCE |
TV-29USP
|
It takes a while for the screen to light up or it doesn't even light up at all, but it has a mat | In my case, the TRC was a bit exhausted, I had already tried all the tips... | I talked to the customer and placed a 1r resistor in parallel with l400 and replaced the 3.3k c407 with 4.7k/1.6kv. This is because these TRC are rubbish!!! | Luiz TVMAR |
| CCE |
HPS 2991
|
TV would turn on for a second and turn off | Q404 short | I just replaced it and the TV started working again | FLAVIO ARAGÃO |
| CCE |
HPS-2197FS
|
Blue screen with no image and sound, image is distorted | Q-101 bc337/25 defective | Replace the same | claudio souza |
| CCE |
HPS2991
|
Does not turn on, LED is off. | Power supply | Replace fr804,q806,d807 and also ci801 | juares soria |
| CCE |
HPS-2071
|
No plot | Fr901 (open) the same is located on the rgb board | Replace the same | Jarbas (ELETRO-SERV) |
| CCE |
TV2118USP/AV
|
Does not turn on when turned on dark band right side | Bad plate and cap.417 | Resolder main board and replace cap.417 | eletronicaapolo |