Cce Repair Tips
Search: cce
Results: 4816
Results: 4816
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| CCE |
HPS2991FSF
|
When it is left off for more than an hour, the TV turns on and after a couple of minutes it turns off by itself and just keeps disarming. | In addition to predicting casual problems characterized by lack of inertia. (c829 / 825/ 869 /868, I noticed a low current in the +b of the fly./ | I replaced it in addition to the others, q802/805. r420 (replace without testing) good luck | ZAK ELETRONICA |
| CCE |
HPS 2071
34BI |
TV with blurred image and colored bands | Open resistor fr0403 | Replace for another | adriano SB |
| CCE |
HPS2997FS
|
Turns on and after a few seconds turns off | Q802 open | Replaced it was ok | lourenço |
| CCE |
HPS2991
|
LED lights up straight and TV doesn't turn on. | Normally, the LED flashes before it stays on. | Q804 - bc337 | Ádrian Chapadão do Céu-Go |
| CCE |
HPS 2706
|
Does not turn on LED lights up when turned on LED turns off but does not turn on +b 115v normal +b 16v with 8v | After changing the 470uf x25v capacitor, checking the entire 16v line, I ended up changing the d 808 sk3gh06 diode and it was resolved. I measured this diode with all the analogue test scales and with another digital one, always indicating good. | If in doubt, replace this diode without thinking | Rolf |
| CCE |
HPS2071
|
Only tunes to one channel in all positions, and loses signal until it's just drizzle | Q101 bc 337 | Replace face! | Ádrian Chapadão do Céu-Go |
| CCE |
HPS 7071
34BI |
TV doesn't pick up sound channels in drizzle | Resistor r105 altered or open killing the 33v voltage on the channel selector | Replace the same | adriano SB |
| CCE |
TV2118USP/AV
|
Horizontal with a black stripe on the left side | C829 de 33uf160v | Replace | EletroClaudio Aguas Belas |
| CCE |
HPS 21AVP
|
Turns on and off with blinking LED | Sw-701-702-703-704-705 | Replace and analyze surrounding components | ELETRONICA MEDEIROS |
| CCE |
TV2118USP/AV
|
Turn on and off | D 813 | PAULO CASTOLDI | |
| CCE |
HPS2071
|
Noise in flaybeck | Remove the vertical outlet and replace it | DAVI PEIXE-BOI | |
| CCE |
2118USP
|
Flyback noise | C429, 334j without capacitance | Replace | |
| CCE |
TV29USP
|
Distorted image with dark band on the right side. | Vertical o ic 301 stv 8179f | Replace for the same or equivalent. | Edigar de Souza Moulaz |
| CCE |
HPS 2001
|
Washed canvas | Vertical ci IC 301-TDA9309 and FR402 and 403 of 1Ω. | samuel leite | |
| CCE |
HPS2171FS
|
LED flashes, tries to turn on and goes to stand by | Without +b9 and +b8v | Dz 606 shorted (8v2) | jasvan souza |
| CCE |
TV2118USP
|
Interference in the image serrated and reduced left side | Cap. c417 331/2kv | infoaçu eletronica | |
| SOM CCE |
MD 3032
|
Doesn't start | Transformer defect | After the replace it started working again | |
| CCE |
HPS3407
|
TV turned on and off | Capacitor eletrolitico de 100mf/160vlts | Just replace it and you're good to go again | plramos |
| CCE |
TV-2918USP
|
Turning off before the image appears | I got the tip from my electronics friend Arthur from hps2071. who says that to know wsound the def is, remove the two protection trans. in my case q404 and q405, if it works normally, take a look at this line | In my case it was open q404. Here's a tip for this entire line that uses this protection. | antonio nobrega(patos pb) |
| CCE |
TV2118
|
Try to turn it on, the LED blinks and returns to horizontal stanby, heating up a lot | Short fly back | After removing the deflector connectors, the fly back smoked, just replaced it. | BETO ELETRONICA ACRELANDIA ACRE |