Hitachi Repair Tips
Search: hitachi
Results: 1065
Results: 1065
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
HITACHI |
C2546TN
|
Red cast to pic when col control increased | Ic501 tda4665 dig delay line chip | ||
HITACHI |
C2546TN
|
No sound | Memory chip replaced | ||
HITACHI |
C2546TN
|
Intetmittantly cuts out | Resolder ic951 | ||
HITACHI |
C2546TN
|
Int reverts to st/by | Dry joint on r956 to left of reg & check reg joints | ||
HITACHI |
C2546TN
|
Int operation then dead | Check dry joints ic950, ic951, ic952 & if still faulty replace ic950 | ||
HITACHI |
C2546TN
|
Int excess width - provoked by tapping | Q752 bc558b breaking down | ||
HITACHI |
C2546TN
|
Int cuts out | Dry joints ic951 8v reg lm7808 | ||
HITACHI |
C2546TN
|
Int buzz esp at sw on | L901 mains i/p filter choke | ||
HITACHI |
C2546TN
|
Field fault | R909 had a invisible dry joint | ||
HITACHI |
C2546TN
|
Field collapse | Dry joint r710 near fop chip (hidden by glue) | ||
HITACHI |
C2546TN
|
Field collapse | Check for dry joints fusible res in psu | ||
HITACHI |
C2546TN
|
Dead | Q903 on4584 chopper tr o/c, zd901 4v7 zener & d905 1n4531 s/c | ||
HITACHI |
C2546TN
|
Dead | Although the line output transistor was reading ok is was breaking down on load | ||
HITACHI |
C2546TN
|
Blank raster & no sound - ok via scart | Tuner type e710029 faulty | ||
HITACHI |
C2546
|
Stuck in st/by | Reg ic dry joints & r952 68k hi res | ||
HITACHI |
C2546
|
Int wont start | Check r901 82k, r950 68k, r952 82k and set ht for 146v | ||
HITACHI |
C2544TN G100
|
Hum on sound & patt on pic | C924 470µ 16v, c925 10µ 50v, c927 470µ 25v in 5 & 12v supplies | ||
HITACHI |
C2544TN
|
Trips at 1 sec interval | C924 470µ 16v in 5v supply or r609 1r0 in 27v supply o/c | ||
HITACHI |
C2544
|
E-w correction faulty | D702, c707 & q652 | ||
HITACHI |
C2524TZ
|
St/by only | Dry joints t901 caused zd903 180v o/c?, r901 o/c, q781 & q903 s/c & check r902, r903, r909, r912, r760, r761, r762, r766 & resold dry joints t901 |