Hitachi Repair Tips
Search: hitachi
Results: 1065
Results: 1065
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| HITACHI |
C2166TN
|
Int trips | Remove glue from ic950 & surroundings | ||
| HITACHI |
C2166TN
|
Int trip | Ic952 5v reg faulty | ||
| HITACHI |
C2166TN
|
Dead with dim st/by light | Dry joints ic902 | ||
| HITACHI |
C2164TN C2564TN
|
Wont start , just momentarily energises then dies | Check 25v supply to audio | ||
| HITACHI |
C2164TN
|
Trips at sw on | Tda7263m audio o/p chip s/c | ||
| HITACHI |
C2164TN
|
To check psu - remove q904 & sw on | If no volts replace r901 82k, r909 6k8 | ||
| HITACHI |
C2164TN
|
Shuts off int | Zd701 pt no 2339251m | ||
| HITACHI |
C2164TN
|
Int trip | Zd701 pt no 2339251m | ||
| HITACHI |
C2164TN
|
Int start up - ok once going | Dry joints q954 emitter in st/by sw cct | ||
| HITACHI |
C2164TN
|
Dead - psu shut down | R901 82k 1/2w in psu | ||
| HITACHI |
C2164TN
|
Dead | Check for dry joints r719 in trip cct | ||
| HITACHI |
C2156TN
|
Dead - trips once or twice at sw on | High ht - r950 68k hi res | ||
| HITACHI |
C2156/2186
|
Ht setting | 110v | ||
| HITACHI |
C2156 - C32WD2 &TC
|
Int goes to st/by | Vr951 +b ht preset 1k goes int or microphonic | ||
| HITACHI |
C2146TN SERIES
|
Dead or int dead | Dry joints r956 1k (under bob of glue) | ||
| HITACHI |
C2146TN ETC
|
Trips soon aft sw on | Dry joints r719/716 (lh rear of loptx)- hard to access, also check r905 0r5 or 2x 1r in parallel | ||
| HITACHI |
C2146TN ETC
|
No sound | Tda7263 audio o/p chip | ||
| HITACHI |
C2146TN
|
Shuts down onto standby | Check ic950,ic951 and ic952 for dry joints | ||
| HITACHI |
C2146TN
|
Mode set up menu | Switch on holding in "vol+" & "vol-" together; model no now displayed on screen; press 2 x rec buttons on hset together to display vers & standard; version 46 v1.0 (later ic v2.0c)....standard....i (for uk)..adjust with key 9....l.......key 8...dk.....key 0 bg.. 7...default...0 1 to 6 alters value tv button return to 0...a18 programme up button adjusts value.....loo programme down value adjusts value .....if h shown set is hotel mode....and is removed by -/-- button....after adjustment put set into standby... | ||
| HITACHI |
C2146TN
|
Int st/by | Ic950 dry joints |