Hitachi Repair Tips
Search: hitachi
Results: 1065
Results: 1065
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| HITACHI |
C2508T
|
Unstable pic until heated | C922 faulty | ||
| HITACHI |
C2508T
|
Long time to come on | Mains smoothing cap 150µ 400v virtually o/c | ||
| HITACHI |
C2508
|
Tuner drift on upper bands | Zd101 33v stab | ||
| HITACHI |
C2508
|
Int dead & makes screeching sound when it does | Mains smoothing cap 150µ 400v low cap | ||
| HITACHI |
C24WXX/28WXX
|
Ht setting | 152v | ||
| HITACHI |
C24W511TN
|
Int reverts to st/by | R959 15k was making int contact with the board (production fault) | ||
| HITACHI |
C24W410SN
|
Eht surge at sw on then reverts to st/by | Dry joints on ic951 and ic952 (voltage regulators) | ||
| HITACHI |
C24W410SN
|
Eht crackling with ht too high | Zd950 o/c 10 volt special zener t536207 also replace c601 and c611 220mfd | ||
| HITACHI |
C24W410
|
Int cuts out - esp when tapped | Dry joints vr950 under plastic frame | ||
| HITACHI |
C24W410
|
Int crackle on sound | R4005 & 4009 47r in audio o/p cct | ||
| HITACHI |
C24W1TN
|
Slow to or won't come out of st/by | Caused by the micro program initialization not getting past auto greyscale sequence due to a1 setting too high - adj a1 as per service instructs | ||
| HITACHI |
C24W1TN
|
Int reverts to st/by | Dry joints ic951, q601 & q602 reg | ||
| HITACHI |
C24W1TN
|
Int off - esp when tapped | Dry joints vr950 in psu | ||
| HITACHI |
C2416TN
|
Sound missing | Memory ic002 | ||
| HITACHI |
C2236
|
White shadow lhs screen | Check c715 ( 2.2uf 350v ) | ||
| HITACHI |
C21P228
|
Int trip | C715 dry joints | ||
| HITACHI |
C2166TN
|
Trips off soon after sw on | Dry joints r719 in trip network, also checks for drys on regs | ||
| HITACHI |
C2166TN
|
St/by only aft poor start up | Dry joints ic952 (under plastic rail) | ||
| HITACHI |
C2166TN
|
St/by only aft initial eht rush | Dry joints ic951/2 | ||
| HITACHI |
C2166TN
|
Sound absent | Ic002 hitachi part no. e730045 |