Hitachi Repair Tips
Search: hitachi
Results: 1065
Results: 1065
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
HITACHI |
C15P108 SALORA L
|
Text ok but no picture | Pfo1 220r preset o/c feeds pin 34 tda3301 | ||
HITACHI |
C15P108 SALORA L
|
Slow start up | Cn10 1000uf 35v | ||
HITACHI |
C14P218
|
St/by only | R902 82k o/c, r903 82k o/c | ||
HITACHI |
C1474R
|
No sound | Ic201 tda4503 - pin 13 should be 3.2v but read 0v | ||
HITACHI |
C1474R
|
Dead | Zd910 s.c. bzx79c2v7 | ||
HITACHI |
C1422R
|
Psu off with a bang | D801 bridge rect db107g s/c, chopper q801 irfi630g s/c, d805 bzt03c130 130volt 1.3watt zener s/c, r814 0r39 1/2w o/c. r813 0r22 1/2w o/c, q404 but11ax loptr s/c, or fit t9813136. chs code -12022tm (expensive) | ||
HITACHI |
C1420VT
|
St/by only | Prot tr tr7550 faulty | ||
HITACHI |
C1420VT
|
No pic/sound | No tuning volts - 33v stab ic faulty | ||
HITACHI |
C1420VT
|
Crack from loptx & st/by only | Replace loptx | ||
HITACHI |
C1415T
|
No picture/sound ok | No line drive as q701 bf459 dr tr o/c | ||
HITACHI |
C1414T
|
Stuck in st/by - no line drive | Safety thyristor q703 ts0820-20 faulty - check by removing - set should then work | ||
HITACHI |
C1414T
|
Off no st/by led | 82k 0.5w start up res r901 o/c | ||
HITACHI |
C1414T
|
Dead with zd952 prot zener s/c | Ht too high - r951 39k 1/2w o/c | ||
HITACHI |
C1414R-311
|
Dead | Q903 on4584 chopper s/c r951 39k hi res | ||
HITACHI |
C1414R
|
Dead , q703 thyristor switching | Check/replace zd701 36v | ||
HITACHI |
C1414-300
|
Dead - q903 on4584 s/c chopper tr | Replace with hitachi but12af & r951 39k 0.6w metal film | ||
HITACHI |
C1411T
|
Only store 1 chan - in skip mode & r/c locks | 27mhz xtal in txt pcb | ||
HITACHI |
C1411T
|
No txt , r/c & chan skipping | Txt chip it01 xtal osc inop. xt01 replaced | ||
HITACHI |
C1410R
|
Tuning goes off slightly | Vl08 bc858c sm in afc cct; vf06 bf840 sm | ||
HITACHI |
A7 SERIES
|
Short pic | Check value of r602 or 603 (1r - 2r2), they can increase in value slightly |