Mitsubishi Repair Tips
Search: mitsubishi
Results: 1346
Results: 1346
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| MITSUBISHI |
TC1418PS
|
Black lines on the top of the tube and changing vertical feed | Cause none c451 | eletronica shalon | |
| MITSUBISHI |
TC2009
|
Time it turns on, time it doesn't turn on | C 906 c 908 (power supply) | Krul | |
| MITSUBISHI |
TV1499 OU1492 LAV
|
Slow blinking led | Zener 6.2 at the power supply was leaking | apolo tres coraçoes m.g. | |
| MITSUBISHI |
TC2018
|
TV without video | An increase in voltage at pin 11 of the micro m52771asp to 3v (normal is 1.1v) | Replace the 10k 503 resistor with a new one. | Ademir solânea pb |
| MITSUBISHI |
TC-2018
|
Stays on standby | Check ic 251, regulator 7809 with problem | pardalzito | |
| MITSUBISHI |
TC 2098
|
When turned on, it lights up stand by and tries to oscillate once, then press power and it doesn't work. | You can see that when the LED is plugged into the socket, it lights up weakly and then brightly but nothing. | Disconnect the kinescope pacifier if the tv works replace the trc. | Dé Andrade |
| MITSUBISHI |
TC 2098
|
Reduced picture, looking like a bad power supply capacitor. | Normal power supply. | Replace horizontal width capacitors, 4.7 and 5.6x1600volts. | Dé Andrade |
| MITSUBISHI |
TC 2099
|
Does not oscillate power supply, no voltage in the power supply secondary. | TV does not turn on or the standby LED lights up | R 904 of 47k it was open - replaced it and that's it. | José Adriano |
| TV MITSUBISHI |
TC 2099
|
Tv works normally with lack of horizontal synchronization the image does not work | Change the elect c 705 cap next to the micro | domingos macedo | |
| MITSUBISHI |
TC2098
|
LED lights up normal power supply does not turn on | R 561 of 10 k open | Roque | |
| MITSUBISHI |
TC-2018
|
Power supply does not operate. (it is not even on standby) | C 913 aberto (220mf x 25v) | TVCompany | |
| MITSUBISHI |
TC-2018PS
|
No colors | Micro | Replace micro m5277 | joaomvjr |
| MITSUBISHI |
TC-2018PS
|
When cold tune out warping image | Varicap | Varicap resoldering or replacement | |
| MITSUBISHI |
TC 2099
|
Doesn't start | R900 because of the short in ic 901 also change c 905 and c906 | ||
| MITSUBISHI |
TC 2099
|
Vertical with bands at top and bottom | C457 | ||
| MITSUBISHI |
TC2010
|
Normal power supply, but without generating high (oscillate). | T552 (horizontal driver) with open primary coil. | CARLOS MAIA | |
| MITSUBISHI |
2098/99
|
Does not turn on / stand by blinking | Check: r661- ic 953 - photocoupler - panel buttons | tyko | |
| MITSUBISHI |
TTC-2098
|
Reduced frame | Reduced capacitance | C 555,556. | |
| MITSUBISHI |
TC 2098
|
Standby LED flashes and does not turn on | Power supply capacitor c 907 change attention note...do not test on the capacitor as it will give the right capacitance but does not work on the circuit | joão dantas | |
| MITSUBISHI |
2018PS
|
Keyboard stuck and no characters appear | Exchange of 470mf/16v diode d953 and c956 |