Mitsubishi Repair Tips
Search: mitsubishi
Results: 1346
Results: 1346
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| MITSUBISHI |
TC 1418
|
Stop r571 open. | Cond.c567 of 4.7 mf x250v change the resist.r571 and the capacitor.they are together close to f. b. | kin | |
| MITSUBISHI |
TC1418
|
R571 heats up and burns out. The TV stops. | Cond.c567 of 4.7mf x 250v replace it. is along with r571 | kin | |
| MITSUBISHI |
TC-2009
|
The device has a loud noise at the power supply. | Electrolytic capacitor: c-903, main supply. | Replaces c-903, 220μF x 400v. it's ok! | Cláudio Ribeiro, TECNOSAT ELETRÔNICA E INFORMÁTICA, Jataí-Go, |
| MITSUBISHI |
2098
|
Vertical closed | Resistors 562 and 960, both 4r7 and vertical output/sms replace | euripedescf | |
| MITSUBISHI |
TC-2009
|
Channel locked | With the control, enter the locked channel/menu/tuning/channel lock/password number and press the channel return key 4 times (the one with two arrows facing each other) | After unlocking, to tune go to automatic tuning, press and hold vol+ | paulorusso |
| TV MITSUBISHI |
TC 2009
|
Reduced image on the sides | Component wear | C 563 4k7 1600kv | Francisco Ivan Basilio - Ibiara-PB - Nova ELETRÔNICA |
| MITSUBISHI |
TC2099
|
Tips on how to trigger automatic tuning. | Menu/tuning/function/auto tune off/volume + | Wait for 5 seconds with the volume + button on the remote control pressed and the TV starts tuning by itself. | edsomvideo |
| MITSUBISHI |
TC 1410
|
When turning on, the stand by LED stays on, the power key activates and the screen flashes continuously, the power supply oscillates so that it is not possible to read it. | Open 100r resistor 908 | Matões A.Técnica | |
| MITSUBISHI |
TC1499
|
Does not light up on standby, and has no power supply voltage. | Ic901 (str s6707) with internal transistor shorted between base and emitter, replaces continued inoperative cause r900 (3.3) open, when replacing functional TV but no video with normal plot, causes c122.2mf/50v trail open on the positive terminal. | Ademir tc | |
| MITSUBISHI |
TC-2999
|
No video and dark screen, normal audio. | R652 on kinescope board changed. | Substituir r652 | NARDINHO-ALFENAS |
| MITSUBISHI |
TC1410
|
Low power supply and heating horizontal output | Deflector | carlaosbc | |
| MITSUBISHI |
TC2099
|
Locks functions | TV off, press channel + and - until it turns on | Function lock, turn it off | ELETRONICA MAURI JUNIOR |
| MITSUBISHI |
TC2010
|
Does not turn on, LED is off. | It doesn't have 5v | Bad contact on pin 9 of t901 | Evandro Estrela |
| MITSUBISHI |
TC 2009
|
Oscillates and goes into `standby` protection | D552 shorted, possible vertical shorted too. Tsound's no point in loosening it, you have to change it | Gutierre | |
| MITSUBISHI |
2099
|
Does not turn on blinking LED, low power supplys | Primary capacitors | Replace c-905,906,907 | WARLEY CESAR |
| MITSUBISHI |
TC2010
|
Vertically closed, touch the plate to open it, but the light streak is tortuous, suggesting that it was the deflector coil | Poor contact in the connection socket with the vertical deflection coil. | It was resoldered and it was ok | Armando de Olimpia Eletronica EvoluSom. |
| MITSUBISHI |
TC-2098
|
Power supply arms and disarms | 07. | Replace. | Edigar de Souza Moulaz |
| MITSUBISHI |
TC-2009
|
Diagonal lines over the image, on all channels, also on av. | C-206 | Replace it | Ronan Nolasco |
| MITSUBISHI |
TC 2099
|
Image with little brightness | R 559 open (connects the 170v to the acl"abl") | ||
| MITSUBISHI |
TC 2010
|
Ic 901ice1qs01 ic 951 tl 431 | sidney valentina |