Mitsubishi Repair Tips
Search: mitsubishi
Results: 1346
Results: 1346
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| MITSUBISHI |
TC2099
|
Bands passing behind the image. | C705 and c703 of 1mf x 50 volts without capacity. | It was replaced and resolved. | Armando Eletronica EvoluSom, Olímpia |
| TV MITSUBISHI |
TC 1418PS
|
Perfect image in RF, but no color | Cold soldering | Resolder or jumper that does not ground | Eletrônica Nel |
| MITSUBISHI |
TC2099
|
Inoperative, LED blinking +b of the power supply varying. | C907 22uf/100v sold out. | edsomvideo | |
| MITSUBISHI |
TC-2098
|
Power supply makes noise in stb. | Ic 951 se115 | ELTON CASTRO embú-sp | |
| MITSUBISHI |
TC-2099/1499
|
Does not turn off | Q-952 c1744 | With fury | ELTON CASTRO embú-sp |
| MITSUBISHI |
TC-2010
|
Doesn't start. (LED turns on and off when you press the on/off button, but it does not generate high voltage | C-573 = 150pf on pin 01 of the horizontal drive transformer. (note. do not measure, change. in my case the measurement showed 153 pf.) | FERNANDO S | |
| MITSUBISHI |
TC2099
|
Image shifted to the left | Open horizontal phase adjustment trimpot (vr501) close to the seletronic. | alexsts | |
| MITSUBISHI |
TC 1499
|
It would turn on and then turn off/stay on standby. | Trc, cracked near the deflector. | Changing the trc worked, but it was only in av, I replaced the eprom ic 702 and everything went back to normal. | PAULÃO-SERTANEJA |
| MITSUBISHI |
TC-2009
|
The device does not come out of stand by. | Electrolytic capacitor c-551, 1ufx160v, defective, is close to the horizontal drive, replace it with one of 4.7ufx160, it is ok. | Cláudio Ribeiro, TECNOSAT ELETRÔNICA E INFORMÁTICA, Jataí-Go, |
|
| MITSUBISHI |
TC2051
0000 |
Agc amplifier with low amplitude | Trimpote 101 | Just replace and adjust. good luck! | Jhone eletronica |
| MITSUBISHI |
TC 1498
|
TV does not oscillate, horizontal heating | The cause was q553=2sd2506 defective horizontal output | ELETRÔNICA MELO-BOA VIAGEM-CEARA | |
| MITSUBISHI |
TC20A
|
Dark image without contrast | R559 opened or changed | Replace r559 180k and blz | robson fabiano |
| MITSUBISHI |
TC-1418PS
|
Vertical closed and it is not the vertical exit | Ic oscilador m52771asp | Replace | EletroClaudio Aguas Belas |
| MITSUBISHI |
TC1418PS
|
Black lines on the top of the tube and changing vertical feed | Cause none c451 | eletronica shalon | |
| MITSUBISHI |
TC2009
|
Time it turns on, time it doesn't turn on | C 906 c 908 (power supply) | Krul | |
| MITSUBISHI |
TV1499 OU1492 LAV
|
Slow blinking led | Zener 6.2 at the power supply was leaking | apolo tres coraçoes m.g. | |
| MITSUBISHI |
TC2018
|
TV without video | An increase in voltage at pin 11 of the micro m52771asp to 3v (normal is 1.1v) | Replace the 10k 503 resistor with a new one. | Ademir solânea pb |
| MITSUBISHI |
TC-2018
|
Stays on standby | Check ic 251, regulator 7809 with problem | pardalzito | |
| MITSUBISHI |
TC 2098
|
When turned on, it lights up stand by and tries to oscillate once, then press power and it doesn't work. | You can see that when the LED is plugged into the socket, it lights up weakly and then brightly but nothing. | Disconnect the kinescope pacifier if the tv works replace the trc. | Dé Andrade |
| MITSUBISHI |
TC 2098
|
Reduced picture, looking like a bad power supply capacitor. | Normal power supply. | Replace horizontal width capacitors, 4.7 and 5.6x1600volts. | Dé Andrade |