☰

Mitsubishi Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: mitsubishi
Results: 1346
Make Model Symptom Problem Solution By
MITSUBISHI TC-2910
Vertical closed and burning horizontal exit C201 470mf/16v shorted next to ic251 Replacement paulo-maceio/al
MITSUBISHI TC-2018
TV cutting out sound and not obeying commands either on the panel or on the remote control 5v supply on the clock and date line and high vcc Check the entire power supply including the load diodes (connected to ground) the power supply must be 5v round CSOM-(066)34231060
MITSUBISHI TV-2099
Blinking led C 901
MITSUBISHI TC2910
TV with two wavy bands on the sides After measuring almost everything in the horizontal sector I found an open resistor r561 of 4 r7 It was just a matter of changing it and the TV was ready! plramos
MITSUBISHI TC-2098
Vertical closed and scratches at the top of the screen Low voltage at the power supply and burning r456 D458 shorted vertical output shorted replace these components, when opening the vertical if scratches appear on the screen at the top of the screen replace c453 it is not necessary however if you want to replace c459, c457 is optional and go for the hug ffeet
MITSUBISHI TC 1499/2099/TC20A
Normal image but with diagonal bars going up behind the image Was it worth changing the 1uf/50 c705? JUVENAL PICOS-PI
MITSUBISHI TC-2090
Does not turn on, and you can only hear the noise of the horizontal working. R-562 open Carbonari
MITSUBISHI TC 2099
Has audio but no sync Q 705 short JF ELETRONIC
MITSUBISHI TC-1409
Image with little brightness as if the tube was weak R 559 of 220k open on the abl line Replaced solved the problem NOELSON
MITSUBISHI TC-1410
The TV stays on stand by in power on, the Apga LED but the TV doesn't turn on It gives the impression that the TV is going to turn on, but the power supply keeps oscillating On standby measure the voltage on the collector q551 (voltage on standby by 114v dc) any voltage drop on this collector could be a three-component leak (q551, c573 or c572) Marcio Rossi
MITSUBISHI TC-2099
The stand-bye LED flashes, accompanied by a pulsating noise at the same intervals as the LED. Power supply capacitor - replaced power supply capacitor c907 (TV works perfectly again) Replaced power supply capacitor c907 (TV works perfectly again)
MITSUBISHI TC2098
PCB-MAIN 		Vertical closed yellow line R-458 22k
MITSUBISHI TC2098
TV with a line in the middle of the screen from top to bottom C574 ​​just change it and that's it plramos
MITSUBISHI TC2099
Timing Replace cap. c208 1/50v digitos
MITSUBISHI. TC2097, 2098E, 2099
If the power supply only gives 50 volts and does not give 120v, the LED will just blink. Capacitors c907 and c906 with low capacity. In place of c907 with one of 22μF for 100 volts and in place of c906 for one of 47μF for 25 volts. ARMANDO DA ELETRONICA SÓ TV.
MITSUBISHI TC2090
No color Fiu First look at the service key, it also removes the color EVOLUSOM
MITSUBISHI TC-2098
Does not come out of standby Replace c905 de 220mf x 16v Persio(TVCOMPANY)
MITSUBISHI 14
ñ it works R 906 (brown,black,brown) Replace it FURAO
MITSUBISHI TC-1631
Image is black and white, you have to pay for color Change the service key in the vertical region or leave it without the key ok Help yourself leave your tip ELETRONICA ARNI-LEOBERTO LEAL /SC
MITSUBISHI TC-1631
Vertical keeps closing sometimes it opens Change the service key in the vertical region or leave it without the key ok Help yourself leave your tip ELETRONICA ARNI-LEOBERTO LEAL /SC