Mitsubishi Repair Tips

Search: mitsubishi
Results: 1346

Make	Model	Symptom	Problem	Solution	By
MITSUBISHI	TC-2099	Doesn't start	Change d 952 was shorted	Replaced resolved	Eronaldo
MITSUBISHI	TC-1631	High power supply, shorting out the zener d909(120v)	Capacitor c917(10mf x 160v) descapacitado.		Persio(TVCompany)
MITSUBISHI	TC 1492	Fountain knurling with buzzing.	Capacitor c 909=4.7 for 160v, no capacity.	The same was replaced and only joy.	Armando da Eletrônica só Tv.
MITSUBISHI	TC1498 1498	Tracks passing diagonally across the screen	I changed all the capacitors on a computer, and the device started to work normally		adelmo
MITSUBISHI	TC 2098	Turns on, after turning off, it doesn't turn on again	Check ci 901 feedback components	In my case, the cap. 905 of 220 by 16v was exhausted	JUNIOR SYSTEM ELETRONICA
MITSUBISHI	2098	Gray screen with no characters	Rusty pipe socket	Replace the same	This email address is being protected from spambots. You need JavaScript enabled to view it.
MITSUBISHI	TC-2009	Connects with very high power supply giving the fly	Changing photocoupler may be shorted	Replaced resolved	Eronaldo
MITSUBISHI	TC-2009	League clicking	Wide capacitors 6n8 or 4n7	Vericar c de 6n8	Eronaldo
MITSUBISHI	2099	When pressing the power key, the TV turns off but the tube filament remains lit	Power transistor q952 connected to the photo coupler		This email address is being protected from spambots. You need JavaScript enabled to view it.
TV MITSUBISHI	2097	Outside the horizontal frequency	Changing the 1/63 volt c208		jaironuness
MITSUBISHI	TC-2018PS	I'm sound, mute	Micro m37372m6-325sp	Device without sound, it was on mute, when I replaced the computer the device started working again.	spectroneletronica
MITSUBISHI	TC2098	Mitsubishi md tc 2098 tv that doesn't fire, the power supply's primary is all normal, the secondary voltages are all present and the led lights up normally. when we turn it on it makes a small noise and doesn't fire at all, I fixed practically everything on the control panel .	The defect was a shorted power supply transistor, I already replaced it and the solution was the transistor q952 2sc 1740		Franklin
MITSUBISHI	TC29 FS ...	Image folded a little upwards in the middle with return lines and at the bottom of the screen a small strip with a small fold on the sides.	In the 35v power supply formed by the flyback tsound is a 3,300uf by 40v capacitor, with low capacitance.	It was replaced for a new one and it was... ok.	Armando
MITSUBISHI	TC2118	The TV turned on normally but the colors were as if it were in NTSC or PAL-N OBS. it's not palm	I replaced the x603 and x601 crystals. It didn't solve the problem. I replaced the ci m52771-asp. It didn't solve the problem. I almost went crazy. So I used it and demagnetized the tube.	With the demagnetized tube the problem was solved	otecnico
MITSUBISHI	TC1418PS	It just stays in stand-by at +b normal voltage	R-571 amended	Replace the same value and 8r2-3w metal film	samuel leite
MITSUBISHI	TC-1499	No image, normal sound, no characters.	No image, normal sound, increasing the screen shows the plot, does not show characters. incorrect voltage on pins 25 and 26 of ic701. defect q705 (c1740) shorted, I put a c1815 in its place. Note: c703, 704, 705, 706, 707 and 710 (1 µf) had very low capacitance and should be replaced.
MITSUBISHI	TC-2999	Tv mitsubishi tc-2999 no picture, normal sound	Mitsubishi tc-2999 tv without image, normal sound, normal mat and filament. As the screen increases, retrace lines appear. does not show characters. defect r680 (100k 1/8w) open on the kinescope board.		littlecarlos
MITSUBISHI	TC 2010	TV starts power supply with +b very high +- 200v instead of 115	Ci audio output short (It's a good idea to always check if tsound isn't even a short in the secondary)		DEBIQUE
MITSUBISHI	TC2098 .......	Image shakes.	Open and close the lines that form the image frame and turn off the TV.	Cold solder on the vertical output IC and nearby capacitors and also resolder the chroma IC terminals.	Armando
MITSUBISHI	TC-1418PS	Str g5653 getting very hot and burning	Diode d913 1n4148 open		Resistronic