Mitsubishi Repair Tips

Search: mitsubishi
Results: 1346

Make	Model	Symptom	Problem	Solution	By
MITSUBISHI	TC2099	TV stuck in function lock	1) with the TV turned off, press the channel + button and then the channel - button. the TV will turn on;		heliomar
MITSUBISHI	TC2099	TV stuck in function lock	Unlocking mitsubishi mod tv. tc-2099		heliomar
MITSUBISHI	TC 2099	Poor focus, no visible image appears (blurred tube)	Bad tube socket	Remember that one hand washes the other.	Marcone This email address is being protected from spambots. You need JavaScript enabled to view it.
MITSUBISHI	TC1498	Black stripes passing diagonally across the screen	C-705	Capacitor replaced near bnmicro c-705	edivaldo
MITSUBISHI	TC-2098	Does not oscillate the primary power supply	R-904 = 47k x 1/2w		FERNANDO S
MITSUBISHI	TC2098	Closed vertical.	With the TV unplugged, we placed an external power supply on the +b 25volt line that polarizes the vertical, in series with a 40W lamp. The lamp turned on at full brightness. IC 451 was shorted.	Replaced ic451 ta8403k, and the r465 1r opened due to the short in ic 451, the TV returned to normal.	Lucas40
MITSUBISHI	ñ SEI	This TV just has a blinking LED and it doesn't turn on	A 16v 470uf capacitor	It was replaced and it's all good. Friends, I'm sorry I don't know the model of this TV.	This email address is being protected from spambots. You need JavaScript enabled to view it.
MITSUBISHI	TC-2099	All white screen with background lines	24c2 memory replacement	24c2 memory replacement resolved	H.IM ELETRONICA
MITSUBISHI	2098	(image out of focus)	Bad picture tube socket		Marcone
MITSUBISHI	TC2098	No video with horizontal black stripes.	Trimpot vr654=220r cracked, green cathode regulator.	Just replaced it and adjusted it, it was ok.	Armando da Eletronica Só Tv
MITSUBISHI	TC-2098	Low power supply does not oscillate	3r3 power supply resistor in place of the 0.33r resistor	Put the correct resistor 0.33r	Eletroclaudio Aguas Belas PE
MITSUBISHI	TC-2009	Turns off after a few minutes	D714 5v6 changed	Replace	paulo maceio/al
MITSUBISHI	TC 1418PS	It doesn't turn on, it just stays on standby	R 571 and c567 causing heating of r571
MITSUBISHI	TC-2098	Completely stopped, charging the power supply capacitor.	R900 er905 and see if str s6707 is shorted	Just to be sure, replace capacitors c905 and c906	This email address is being protected from spambots. You need JavaScript enabled to view it.
MITSUBISHI	TC1492	Does not accept the power command	C915 and 917 470mx35v replace		@gepê
MITSUBISHI	TC21S QUE USAN O MICRO M327210 E O TDA8361	Agc doesn't work	Change values of c120 and c132	Do not measure but replace c120 2.2mf and c132 82pf	ars
MITSUBISHI	2099	Mitsubishi tc 2099 with sound, white screen with diagonal lines (horizontal phase)	Q 705		renato tranca forte
MITSUBISHI	TC-1410	TV does not oscillate, press the button to turn it on, the LED goes off and comes on again	Cold solder on pin 10 of the fly back and open 8r2 5w r571	Resolder and replace the resistor	eletroclaudio aguas belas
MITSUBISHI	TC-2018	You plug the TV into the socket and it oscillates for 3s and goes into protection mode.	Protection activated	Look at the most critical components such as flyback, horizontal and vertical output, if these have a bullet, measure the voltages of the 901 regulator (str f5654), if the voltages are ok, turn off the diode (953), 18.6v, the TV will turn on and oscillate normally and it will show wsound the defect is, in my case it was the vertical output and the IC (701), this one came from another workshop I believe it was just the vertical one, because the IC 701 had new solder, unfortunately tsound is a workshop that uses From this bad faith, a hug	ffeet
MITSUBISHI	1418 PS	Capacitor 955 bursting and r 952 opening	C 567 sold out 4.7 x 160	Replace the same	urbieta