Mitsubishi Repair Tips
Search: mitsubishi
Results: 1346
Results: 1346
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
MITSUBISHI |
TC 2099
|
Interference on the image as if it were a lack of general synchronism, in rf or av. | C 705 (1mf/50v),replace s/ medir. | Esper | |
MITSUBISHI |
14 NãO TEM O MEDELO
|
No contrast and little color | R559 220k | Replace | EletroClaudio Aguas Belas |
MITSUBISHI |
TC-2099
|
LED flashing, power supply does not stabilize | R908 open near c907 | Resolved by replacing the 10k r908 | PATRICK |
MITSUBISHI |
TC-2010
|
This TV had all voltages on the secondary power supply, ok, but it did not generate high voltages. | Q551(2482) open, and c573 altered in horizontal amplification. | Swapping the two solves the problem. | Eletrônica Barros(Léo) |
MITSUBISHI |
TC-2098
|
With charged capacitor | 47k open r904 | R904 - de 47k | |
MITSUBISHI |
TV2098
|
I'm ruim | Capacitor c305 open | orlando lott | |
MITSUBISHI |
TC 2041S
|
Has difficulty calling, sometimes calls, sometimes doesn't call | R 916-150k open. change.,it may be open or altered. | Perse | |
MITSUBISHI |
TC2090
|
Does not pick up low channels | Probable cause c7 t1- o.01uf- shorted. ceramic capacitor. | Perse | |
MITSUBISHI |
1419
|
Password locked channels | With the TV in stand-by, press on the TV panel, volume + and - simultaneously, wait until it turns on, then go to the menu using the remote control and deactivate the "lock" function, then turn it off and on again. If necessary, repeat the procedure more than once. If you can't, change the memory. | Software reprogramming | Osmar Antonio |
MITSUBISHI |
TV1410
|
Power supply keeps oscillating at 48v when turning off the tr.horizontal output voltage remains normal | Shorted deflector coil or internal leak | Replace the original deflector coil. at1625 | ELETRO CENTER |
MITSUBISHI |
TC-2098
|
Without horizontal synchronization, does not tune channels | Cap. c208,1uf x50 v | pardalzito | |
MITSUBISHI |
TC-2099
|
Doesn't tune in, and doesn't come in | R744 of 8k2 micro pin 41, may be open | Bruske | |
MITSUBISHI |
TC -1409
|
Does not turn on, power supply keeps trying to arm, LED blinks. | C-954 /r954 | Replace the capacitor (runaway) and the open resistor. | WARLEY CESAR |
MITSUBISHI |
TC-2099
|
Image stretched as if it were too tall and with a 2cm black band at the bottom. | C457 2200uf/25v and not c457 220uf/25v (corrected) | ||
MITSUBISHI |
TC-2099
|
Image stretched as if it were too tall and with a 2cm black band at the bottom. | C457 220uf/25v | ||
MITSUBISHI |
TC2009
|
Vertical closed | R462 open | jceno | |
MITSUBISHI |
TC-2098
|
Sometimes it turns on, sometimes it doesn't | D-953,zener 6v8 | paulinho | |
MITSUBISHI |
TC-1492
|
Sometimes it turns on, sometimes it doesn't, without 5v on pin 7 of the computer | Ic-702 pst520e | Replace of the same | paulinho |
MITSUBISHI |
2098
|
Closed vertical two white lines in the middle of the screen | C 457 (2200x25volts) | HP ELETRONICA | |
MITSUBISHI |
TC 2010
|
No color | C605 the 22pf | MACCELETRONICA |