Mitsubishi Repair Tips
Search: mitsubishi
Results: 1346
Results: 1346
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| MITSUBISHI |
TC-2098
|
Turns on then a strip appears at the top of the screen and the 115v drops to 102v, if you lower the brightness it goes away but then comes back, it looks like a capacitor but it's not, believe me. | Check if 953 2sa720 may be shorted | I replaced it, it solved it, good luck. | Eronaldo |
| MITSUBISHI |
TC-2918PS
|
Turns on and off, then doesn't turn on again | C 904, 220yf/35v supply board | I replaced it with 470yf/35v, it was fine | Adrian Chapadão |
| MITSUBISHI |
TC.2099
|
It didn't turn on when it arrived to burn str 6707 | R. 906 10 homs open | Resolved | ELETRONICA IDEAL |
| MITSUBISHI |
TC.2099
|
Doesn't start | An open resistor 906 10 oms | ederci | |
| MITSUBISHI |
TC-2018PS
|
TV turns off by itself | Resolder or pine gnd do fly back | claudio eletronica evolusom olimpia sp | |
| MITSUBISHI |
CT-2101
|
TV with a white screen with lots of brightness and lines of retraces | (ic 651,tda 6107jf) rgb amplifier. | eletroclaudio aguas belas pe | |
| MITSUBISHI |
TC 2018PS
|
Does not turn on, only LED on | Ci m52771asp | Ci replace | AMARO JOSÉ |
| MITSUBISHI |
TC2004
|
Intermittent vertical closing, mainly at the bottom | Cold solder, vertical output ic oscillator v h chroma luminance | Resolder the entire ic fas everything and complete vertical output. | josé carlos |
| MITSUBISHI |
TC2099
|
Does not come out of stand-by | Capacitors - c569-10/160 - c907-22/100 and c905-220/16 | Replace mentioned items | eletronicaapolo |
| MITSUBISHI |
TC2010.
|
The LED only lights up but does not start. | Due to cold soldering in c 952 and c 954, c-962 =100x16v burst. | A 100x25v capacitor was placed in place of c9562 and c952 and c954 was just resoldered and the TV was ok. | Armando da Eletrônica só Tv. |
| MITSUBISHI |
TC2999
|
No video | Resistor r 680 open on the tube pci | Replace of r 680 | Itan,Parelhas,Rio de janeiro |
| MITSUBISHI |
TC2910
|
Dead power supply | DS07 | D907 17.4v zenner incurto made your replace tv turned on | ELTRONICAROCHA FERNANDO ROCHA |
| MITSUBISHI |
TC2918
|
Stand by on, when turned on, the stand by goes off and the power supply drops | Ci se 130 power supply regulator | itan | |
| MITSUBISHI |
TC2099
|
Led standy by piscando | Capacitor c907 | pc | |
| MITSUBISHI |
TC-2909
|
Channel lock | felicidade | ||
| MITSUBISHI |
2099
|
When changing channel grila | Replace c 569 (10x160v) | ||
| MITSUBISHI |
TC-2098
|
Does not tune the channels | Replace c- 124 10n with leak | resistronic.blogspot.com | |
| MITSUBISHI |
2098
|
Reduced frame on the sides, making the pacifier click, and then turns off. | C 556 capacitor de largura 4n7 p 1600v | Attention, replace the c555 also from 5 6. and problem solved | |
| MITSUBISHI |
1418 PS
|
It works normally, after a while, dark bands pass vertically, until the channels disappear. | Defective varicap | I replaced it and it was beautiful. good luck everyone | |
| MITSUBISHI |
TC-2099
|
Turns on with noise from the power supply transformer | Swap c950 1/50v without capacitance | Replaced and plz | Eronaldo |