Mitsubishi Repair Tips

Search: mitsubishi
Results: 1346

Make	Model	Symptom	Problem	Solution	By
MITSUBISHI	TC2099	With image without horiz synchronization.	Cap elet, c705 1/50v		haecio
MITSUBISHI	TC 2098	Poor width	Capacitors 555 and 556 of 5n6 and 4n7	Replace - check the power supply	Moré
MITSUBISHI	TC2010	High power supply	He softened		Carlos
MITSUBISHI	TC2098	No sound and image collector transistor below 60v	Change power supply regulator		eletronica house tuta
MITSUBISHI	2099	Sparking in the socket	Fly back		eletronica house
MITSUBISHI	TC-2040	Absence of color	C-613		Lauri
MITSUBISHI	CS26EX1	Turns on normally, sound and image, after a few seconds tsound is a black picture, with only the image remaining 1 centimeter on the sides	Poor eeprom
MITSUBISHI	TC-2018	Std-by led on, does not start	Solda fria no fly back
MITSUBISHI	TC-1418	Keyboard does not work, turns on does not change channels, does not increase or decrease the sound	R725 changed		Andrade Sequeira
MITSUBISHI	TC-1499	Does not start	C905, c906, c907 next to str6707
MITSUBISHI	TC 1418	White screen with characters	Enter service mode and turn off blank mode		KELSON
MITSUBISHI	TC 2010	Dead	Blown fuse, rectifier, q901 and ic 901 faulty	Shorted rectifier, faulty q901 and ic901	miguelito
MITSUBISHI	TC 1418	Just on standby, doesn't turn on.	Ic 251 faulty 9v voltage regulator, output voltage below normal, triggering protection pin 30 of ic701 (micro) x-ray	Replace ic 251 9v regulator	MAGAIVER
MITSUBISHI	1492	Image was shifted to the left	R511
MITSUBISHI	TC-2099 %%%	The stand-bye LED flashes, that is, the power supply voltage varies	Capacitor 22uf/100v - c907		This email address is being protected from spambots. You need JavaScript enabled to view it.
MITSUBISHI	CT-14MS1EM	On, it only works with channel 0 (zero) and it only gives me ants! If you try to change channels the screen goes black for a moment and returns to channel 0.	In 99% of cases it's the memory you can use a blank memory but the TV will keep the channels skipped then you need to open the channels otherwise you won't leave channel one if it is I'll explain how to do it later (brites). you can use 24c08 and the TV will have 60 channels instead of the current 40. the memory must be empty.	See forum - faults resolved more information about this fault fault ct-14ms1em < /a>	TIRAS - BRITES
MITSUBISHI	TC-2099	Does not turn on, LED blinks	Ss07
MITSUBISHI	TC-2099	LED flashes; doesn't work	Change the three electrolytic capacitors of the 22/100 power supply; 470/16; 220/63
MITSUBISHI	TC-1441	Burns horizontal output	C501
MITSUBISHI	TC-2098	Takes time to exit stand-by	Transistor q703