Sanyo Repair Tips
Search: sanyo
Results: 852
Results: 852
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SANYO |
CTP 3791 S
|
Small frame with lines | Shorted deflector coil | Put a new one | EVALDO GOMES |
| SANYO |
CTP3791P
|
No image in drizzle and turns off after 10 min. | Varicap stopped or intermittent (selector) | Replace to eliminate defect if in doubt. | Schulz |
| SANYO |
CTP3791
|
This TV was dead, the power supply had no secondary voltage. | C616 with a lot of escape. | silva2 | |
| SANYO |
CTP6766U-S
B8-DYTW01 |
With sound, without image. +b from normal tsh power supply and sink. | Ci 201 with bad contact. I redid the soldering and the TV started working normally again. | André Fernandes | |
| SANYO |
C20BG2TX
PT11 |
The switch tries to start, but the power supply vibrates | C607 (7,2nf), q602 (bu208df) | C602 with 5.7nf damages q602 | joaquim cunha |
| SANYO |
CE20TN4
11AK30 |
The colors are blurred | Swap th800 mz72al 9rm | ricardoteles | |
| SANYO |
CTP-6781
|
Vertical shaking | C454 capacitor de 10nf | Replace component | WenderBF |
| SANYO |
CE28CN4
11AK45B5 |
Dark trc, with sound | Vertical non-ic welds | Increase the screen to see vertical opening | joaquim cunha |
| SANYO |
CE20MTN4
PT90J |
Image with dragging | On the 2.2mr trc r plate open | joaquim cunha | |
| SANYO |
C20MNTX
PT90 |
Without image, but with sound | Cv81 (102k 2kv), na placa do trc | joaquim cunha | |
| SANYO |
C20MNTX
PT90 |
No vertical opening | Rd10 (0.2r);cd13 (byw36v); id41 (tda1771) | joaquim cunha | |
| SANYO LCD/TFT |
CE20L02
17MB18-5 |
No image; dark | Lamp power inverter | Psu com volts ok | J.CUNHA |
| SANYO |
C20DN4AVN
PT11 |
League won't start | C8 e c15 (471k 1kv);c11(47uf/25v);c12(1uf/50v) | J.CUNHA | |
| SANYO |
CM28SW3TX
PT92 |
Starter tries to start, LED is green and flashes on sty | Cd55(10nf/100v); ic (tda8351) | J.CUNHA | |
| SANYO |
CEP3037PG
|
Doesn't start | R565 interrupted, replace | kokas | |
| SANYO |
CEP3037PG-01
A3-A14 |
Burning tr mat (q432) | Changed power supply | Replace r555 | CarlosVale |
| SANYO |
CTP6781
|
Very high power supply above 280 volts, does not regulate | Cause: check d351, transistors of this power supply primary and secondary side outside the circuit and mainly the resistor r-350 which in my case was open | ||
| SANYO |
CTP3791P
|
Audio noise on all channels | Cristal x 161 | Place a 47μF/25 electrolytic capacitor in parallel with the primary crystal | AELSON |
| SANYO |
CTP6756U
|
Red color failure. | Trimpot vr612 failing. | Oxidation of the movable parts of the trimpot. | Carlos André Poloni |
| SANYO |
CTP6756U
|
Vertical partially closes after a few minutes of operation. intermittent defect. | Tantalum capacitors on the periphery of the main IC201 integrated. components did not show defects in the static test. requires replacement. | After a few minutes of operation, the TV closed the vertical, leaving a 5 to 6 cm high band in the center of the screen. | Carlos André Poloni |