Sanyo Repair Tips

Search: sanyo
Results: 852

Make	Model	Symptom	Problem	By
SANYO	CTP 3791	Doesn't start	Resistor r601 (120k), open	Sérgio
SANYO	29LH43B 29LH43B	TV turns on and activates the security system, turns off, never opens image	TV turned off and I replaced the vertical ci	nilton melo e siva
SANYO	29LH43B	Sem cor em pal-m	Ci la7680
SANYO	C20DN4 VESTEL - CONTINENTE	Horizontal stroke	R410
SANYO	CTP-3771	Power supply does not start	R520 and/or r521 changed
SANYO	CE28SN4	Tries to start and turns off	Verificar r603 0.47Ω e ic vertical
SANYO	6781	Glossy stripe 3 centimeters wide in the center of the screen and then upwards a fully stretched image	C451 (470mfx16v) -c455 (1mfx50v)
SANYO	C20BG2TXN - CHASSI PT11	Blocking video and sound momentarily. I even worked for hours ok	Tda8361
SANYO	C25EG35N CHASSIS EB2A	It starts and works well for about five seconds, after which it goes to stand-by.	R394 (390k) open.
SANYO	C20BG2TXN CHASSIS PT11	Power supply does not start.	Change the 3.9m resistance that goes from the + of the filtering capacitor to pin 11 of the tda16846 ic.
SANYO	CE14AT2 CHASSIS 2112 / EC7A	No image - with a blue screen as if tsound was no antenna signal.	Tuning circuit ok, resistance r206 (220Ω smd) open.
SANYO	CHASSI EC-1	Image as if it were out of tune, varying as if the tuning voltage was unstable.	Q201 leaking
SANYO	C20DN4AVN CHASSI PT11	Does not start, relatively normal voltages	220uf c31 with little capacity
SANYO	CEP1497E	Tries to start but immediately shuts down by turning off the protection turns on, but without vertical amplitude	Ver c706=470mf/16v
SANYO	CE21AT1 CH. EC-A4	Tries to start by switching to standby.	I had the 3.3m r718 open.
SANYO	CE28FT2 CHASSIS 2110-EB-5B	LED lights up but does not start. Voltages at the power supply are normal.	A damaged bc848. this bc is mounted on a board that is powered by the reset line. when turning on the TV, the reset voltage was 0.16v, instead of 5v.
SANYO	C20DN4AV CHASSI PT11	Turn on the switch tsound are voltages the call is made and it wants to start but the voltage +b goes down, it doesn't work, it stays on standby	See next to the t.s.l the diode 603 (it has a leak)
SANYO	C20DN4AV	Power supply does not work LED off, noise is noted (ticking)	C5 at power supply 100 mf 400 v without capacity
SANYO	C21EF50	Normal (+b) voltage for a few seconds goes to maximum immediately, leed goes to stand by again, stops oscillating [does not work]	See r372 of 390k next to the open tr351 (same tip on another model)
SANYO	21M1-C21EF90	The TV starts up, immediately switching to stand-by	Replace r372 (390k)