Search: sony
Results: 20088
Make Model Symptom Problem Solution By
SONY KDL-40EX252
Perfect image, but no audio In my case, it was the p2 audio output jack, below the vgr Replaced the audio returned to normal João eletrônico
SONY 40BX425
KDL 40BX425
Nothing turns on, not even the panel LED lights up, tsound is 5.2v from the power supply Regulator replacement, position u702 (s1117-33). Toni
SONY KDL-32BX325
LCD
Turns on, works normally, but with the keyboard inactive, and, if you turn it off for a few minutes, and activate power via the keyboard or control, it doesn't turn on. It ONLY turns back on after being unplugged for a long time. Voltage 3.3 out at u701 with drop. Replace u701 = g1084-33 (3v3 regulator) NOTRYL
SONY HCD-R33
Triggering protection Change +b resistors 100 and release the d532 diode Replace and run to the hug renildo
SONY KDL-32BX305 KDL-32EX305
Does not turn on, no standby or standby blinking 2x Voltages are all normal, no inverter. After changing all the boards and harnesses, I decided to change the entire lamp panel. It finally worked, but the original inverter was shorted, requiring the inverter to be replaced or repaired. Changing the complete lamp panel and inverter (or inverter repair) World TV - Sorocaba
SONY KDL-46EX605
The logo appears, the logo sound appears, and then it turns off. and so on without stopping. Missing 1.2v st1s06pur *ic1004, back varicap, side of f1003. Check f1003. It would be good to replace IC1004 or jump 1V from another regulator on the board. Joaomvjr
SONY KLV-46W410A
TV turns on standby light turns green LCD lamp lights up and then turns off and LED turns red and flashes 14 times. I renewed the lid and made sure nothing looked wrong. I decided to use a thermal blower to heat the power supply capacitors. The TV started working normally again. I left the TV off and turned it on again and it showed the same defect. I did the procedure again with the thermal blower and it started working again. I replaced all the electrolytic capacitors in the c6000 group power supply. It no longer presented the defect. ADRIANO MIRANDA
SONY KLV-32M400A
Doesn't start Smd fuse on the main board f4050+smd capacitor under the board shorted next to the ic ic4051, tsound is the capacitor, it was one of them, just follow the line that comes out of the fuse and you will find them under the board, in place of the smd fuse I put a resistor 0r47 reginaldo moronte,eletronica junior caldas novas
SONY KV-29FS100
Does not turn on, the LED flashes 9 times, and returns to standby and repeats the cycle several times. Resistor r693 330k close to the power supply relays. Replace r693 in the power supply. Marcones de Araripina PE.
SONY HCD-EX6
When I plugged the sound into the socket it would turn on and off, only the times I turned it on, neither the CD nor the USB would work. After analysis I found the diode d400 1n4002-a2 which is on the panel PCI it was open, after replacing the sound it works normally again. Jonas
SONY HCD-EX6
Turned off in 3 seconds Defect in the CD part, when I disconnected the flat cables it stopped turning off Jonas
SONY HCD-EC59
Protect Q619- main power on-off Replace q619--2sc3052f EMERSON RIBEIRO
SONY HCD-SH2000
No sound/Audio, does not arm protection/protect, displays please wait when activating USB or CD. Tsound is no 9V power supply for the IC500 audio processor or the 4558 preamps. Transistor q800 and c754 short, resolved by replacing them. EduSSantoz
SONY HCD-GTX88
Does not come out of standby X402 bad 5mhz crystal, just change it (it was measuring around 2.065 k from one end to the other, that is, leaky). Ronaldo Vieira
SONY KDL40BX455
TV turns on red LED lights up turns green and turns back to red and flashes R 9810.... 9811... 9812 remove and scrape the glue underneath RJ ELETRONICA
SONY KDL40BX455
TV turns on red LED lights up turns green and turns back to red and flashes R 9810.... 9811... 9812 remove and scrape the glue underneath RJ ELETRONICA
SONY KLV-40S200A
When turning on the TV, the LED flashes 4 times, no image, no sound. Replacement of fuse f401 - 10a on the inverter board on the left side of the TV Replacing the fuse on the inverter left upper board f401 10a Ferrarini
SONY KDL-55W805C
Turns on, the back light comes on, the Sony logo appears, then turns off and the stand by LED flashes 3 times Shorted smd capacitor next to the ic 8000 close to the cn8001 connector Replace it or leave it without a capacitor Alex Lopes <small>This email address is being protected from spambots. You need JavaScript enabled to view it.</small>
SONY 40EX455
Sony appears and turns off See q6101, q6102 and r6536 and this electrolytic capacitor on the 5 v line c9305 ADAILTON
SONY 40EX455
Sony appears and turns off I replaced all the photocouplers and resoldered all the cis smd and it solved the problem. FERNANDES