Sony Repair Tips
Search: sony
Results: 20077
Results: 20077
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
CDPC211
|
Skips after replacing spindle motor (adjust table height) | Skips in normal position but, plays o.k. on side. adjustmentswould not help. | ||
| SONY |
CCDTR200
|
Sticky iris/cleaned oil from iris | No iris movement. found oil on iris leaves of m904. itlooked like it may have leaked from the lens assembly or zoom motor. | ||
| SONY |
KV27TS27
|
System control, grounded all pins on ic101 and 102 | After wam up, control of functions would not work. bhin insan diego called me and said that replacing the ic102 produced a newproblem. the set would come on in s video with no remote or manualcontrol. he than took out ic102 from a working set, again t | ||
| SONY |
CCDFX710
|
Keeps blowing f-950/check insulation around vf cable | The unit blows f-950. with the cabinet off the units willplay fine. replacing cabinet fuse will blow. 7 wire from the view finderto the main board was shorting. insulated wires and unit appears to workfine.connector cable is not available through par | ||
| SONY |
CCDTR6
|
Part number for ffc-5 and connector (cb-33) | The part number is needed for the ffc-5 flex cable andconnector that make up cb-33. -hq comments: part number for the connector is 1-636-561-11. part numberfor the flex cable (ffc-5) is 1-590-113-11. the ccd-tr9 service manual hasmore information on the | ||
| SONY |
SLV585HF
|
No ee or playback video: resoldered ic004 on yc112 board. | No ee or playback video | ||
| SONY |
SLV700HF
|
Eats tapes: reset cn401 (ma158 board) in proper position. | Unit would load and thread tape. it would not rewind or ejecttape. eats tape during eject mode. the capstan motor was not running inreverse. | ||
| SONY |
SLV70HF
|
Shuts down after 1-2 seconds of play: take-up reel | Unit loads tape, but will only play for 1-2 seconds before it shuts down. | ||
| SONY |
SLV575UC
|
Ticking noise during playback: reset spring ref23 | During playback there was a faint ticking noise. | ||
| SONY |
SLV676
|
Ticking noise during playback: reset spring tension on 213 | During playback there was a faint ticking noise. | ||
| SONY |
SLV585HF
|
Ticking noise during playback: reset spring 224 | During playback there was a faint ticking noise. | ||
| SONY |
D66
|
Unit dead - replace ic804, p/n 8-759-945-21. | Unit is dead. found no reset voltage at ic801/pin 62. therewas also no voltage at ic804/pin 2, the reset ic. | ||
| SONY |
CDX5180
|
Will not load cd (replace open q92, p/n 8-729-402-08) | Unit will not load cd's. | ||
| SONY |
CDXA30RF
|
Part number corrections: antenna jack and antenna plug | The part number for the antenna lead is incorrectly listed inthe service manual. the part received is key top, a complete button.what is he correct part number. -hq comments: the correct part number for the antenna plug is9-996-065-01. the part number | ||
| SONY |
D515
|
The power is on, but no operation - replace q402 (872980676) | Power is on, but there is not operation. switching transistorq402 was found defective. | ||
| SONY |
SPP65
|
Will not charge the battery - cracked pcb | Will not charge the battery - intermittently the charge light on the base comes on. | ||
| SONY |
SPP57
|
Handset will not ring or page - open trace onto sw-501. | Was able to get a line, but the handset would not ring or bepaged. | ||
| SONY |
ITB3
|
No dial tone - replace fuse f1, p/n 1-532-866-11. | No dial tone. no line seize. | ||
| SONY |
SPP57
|
Intermittent no line seize or dial tone - replace l-613. | Intermittently would not seize line, or no dial tone. | ||
| SONY |
CDPC215
|
Skips after replacing spindle motor (adjust table height) | Skips in normal position but, plays o.k. on side. adjustmentswould not help. |