☰

Sony Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: sony
Results: 20100
Make Model Symptom Problem Solution By
SONY CFS210
Will not work on ac Will not operate on ac.
SONY KXM270
Black border on left of screen, cleaned d-21 connector Picture has a one inch black border on the left of screen. itlooks like blanking problem.
SONY CCDF40
Ccdf40 no color e-e No color from camera section - digital superimposer also in-operative. swapped camera section still no color. found color blankingline pin 38 of ic-202 low - lifted pin color came on.
SONY UP811N
Intermittent printing with white horizontal lines Printing intermittently sometimes with white horizontal lines.checked for possible hairline cracks on the pcb as the unit had beenshipped a number of times back and forth.
SONY SPP80
Handset was dead Battery ruptured.
SONY FD500
No power, replaced ic451 and fuse No power. also serial numbers 107931 and 1803426.
SONY EVS700U
No remote control operation No remote control operation. does not respond to hand unitrequests. scoped data from r/c at cn-117 pin 5. data measured 1vpp ...should be 5 vpp.
SONY GV8
Vertical red line at side portion of the screen There is a vertical red line at the side portion of thescreen.
SONY TAF444ES
Burnt volume control and board Board burnt beyond repair - volume control burnt. no partnumber for stuffed board. no replacement units in stock. we require helpin completing this repair (asap) as customer is very concerned and gettingangry. -hq comments: tokyo has the empty board
SONY SPPS10
No talk mode Base unit would not receive signal from handset. foundreceive section operating normally on both channels but unit would notcome on. (in use) led stayed off.
SONY CDP707ESD
Does not read disc Unit will not read disc. after loading, the disc will spinforward for a second then spins backwards and shuts down-then (disc memo)appears on the display.
SONY ICF2010
Improving sensitivity using rod antenna On some units that have been in service for a while the custo-mers complain of poor sensitivity using the rod antenna. external rf in-put is ok. the problem may be caused by two factors. 1. the rf board be-gins to sag and does not permit the antenna c
SONY SPP80
Static noise in battery save mode Unit makes static noise from handset speaker during batterysave mode only. there is no noise in normal mode. this is the fifth uniti have seen with this problem.
SONY SPPS10
Handset power locked on, no functions Received several units that would not go into battery save(standby) mode. removing battery would not reset the unit. when batteryis reinstalled, the battery led comes back on. the handset will notfunction in any way at all. also pertains to serial nu
SONY SLV50
Bad pinch roller Pinch roller forces capstan motor down during operation.
SONY CCDF40
No audio in rec No audio in rec. found c-560 off of the agc circuit to beleaky.
SONY CDPC10
Unit jams after repair Unit jammed after a minor repair - erratic operation would notplay disc. totally unrelated to original problem.
SONY STRAV500
Missing bottom plate part number The bottom plate part number is missing in the service manual.
SONY TCW190
Missing part number Part number for the motor is missing in the service manual.
SONY TAAX435
Malfunctioning function select button When pressing function buttons, leds will light and then goout. no audio switching.