Sony Repair Tips
Search: sony
Results: 20100
Results: 20100
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
CCDF30
|
No horizontal sync in camera position | No horizontal sync in camera position. | ||
| SONY |
GV8
|
Noisy when breaking | Noisy when breaking. take-up-table gear teeth were worn out. | ||
| SONY |
GV8
|
No video out from line | No video out, when line input is used, pin no. 8 on ic-701 isdead. | ||
| SONY |
CDXR7
|
Cover will not snap onto frame/missing indentations | Cover (3-323-287-01) will not stay snapped onto frame(3-323-218-01). frame does not have indentations like original to acceptand hold cover. -hq comments: i am checking with tokyo to see if there were two chassisand covers. | ||
| SONY |
CDXA20
|
D-509 wrong on new mcb jack | Cdx-a20 in for smashed mcb jack and back. replaced mcb andback. noticed elevator ran slow. | ||
| SONY |
EVS1
|
Unit accepts no commands | Unit powers up but accepts no commands. fr-27 and ts-64circuit boards corroded. | ||
| SONY |
KV1380R
|
No picture/white lines at the bottom of the picture, r552 | No picture, high voltage ok - white lines at the bottom of the picture. | ||
| SONY |
SLV70HF
|
No drum rotation | Unit loads tape capstan turns, but the drum does not. thetape is then brought to the half loaded position and all commands aredisabled except eject. | ||
| SONY |
TAAX285
|
Dead amp | Fuse 1 blown no power. replaced fuse had power but no audio.found emitters of q-511, q-512 had 55 volts on them - and were shortedfrom emitter to base. | ||
| SONY |
CFS212
|
Incorrect part number in service manual | Part number in service manual (page 13, reference no. 5)x-3344-323-1, is incorrect. | ||
| SONY |
UP811
|
Multiple picture (repeats horizontally) | The unit prints about the first 1/3 of the picture insuccession from left to right - creating a tripple image effect. | ||
| SONY |
D15
|
No charge of battery | Battery would not charge. charging circuit inoperative.found r-403 incorrectly located on the board and soldered to the collectorof q-433. | ||
| SONY |
CPD1303
|
Vertical fold at top of screen | Vertical fold at top of screen. 80 volt measured on 15 volts.t-654 secondary open. | ||
| SONY |
CPD1302
|
Vertical fold at top of screen | Vertical fold at top of screen. 80 volt measured on 15 volts.t-654 secondary open. | ||
| SONY |
CCDV220
|
Intermittent video dropout | Intermittent dropout in playback picture. | ||
| SONY |
TAAX520
|
Malfunctioning volume control | Volume control operation was erratic. leds did not operatesmoothly - audio was choppy. replaced ic-202 w/ new ic, but when poweredup all but 1 led was on and volume controls (+ and -) had no effect. | ||
| SONY |
TAAX335
|
Part number correction | Part number is not listed in kansas city. | ||
| SONY |
CCDF40
|
No power | No power, no led display and no functions. (ever 5v) measured1.3vdc. lift ic-191/2 and +5vdc restored. | ||
| SONY |
CCDF40
|
No picture in camera mode | Camera has no picture display. | ||
| SONY |
KV1510
|
Horizontal oscillator not running | Dead set. minimal current being drawn from regulated powersupply. vcc present at horizontal output transistor, but horizontaloscillator not running. externally power horizontal oscillator, and bringset up on variac set works ok. |