Beko Repair Tips

Search: beko
Results: 235

Make	Model	Symptom	Problem
BEKO	15325NK	St/by only s/c line dr tr tr801 bc635	Due to field drive int o/p from tea2029c (faulty?)
BEKO	15225NX	Trips at sw on with loud crack	Lopt arcing between a1/focus controls - replace loptx
BEKO	15225NX	Pic shifted to bottom	R725 150k hi res
BEKO	15225NX	Off burning smell	L507 dry joint
BEKO	15225NX	Dead?	D801 by299 s/c
BEKO	15225NX	Dead - fuse blows	T101 s/c - replace t101 buz90af & tda4605
BEKO	15225NX	Brightness varies aft loptx replacement	R1237 1k2 1w o/c in a1 feed
BEKO	15221NX	Pic fades	D1209 on crt base leaky
BEKO	12220T	Dead 55v ht	D111 fr30-02 s/c, u4 supply diode
BEKO	12220NX	The status information appeared on the scrcen at r	The cause of the fault was on the audio panel , where the 17.47mhz crystal q2 was drifting when warm.§
BEKO	12220NX	Status info perm/semi perm displayed	Q2 17.47 mhz xtal on audio pcb drifting
BEKO	12220 10.2	Front cont int don't work	Check momentary contacts on mains sw
BEKO	1220T	Field lin	R725 150k dry joint
BEKO	11AK08	Dead aft thunderstorm	1n4148 diode measured about 460kΩ both ways
BEKO	116328NX	Blank grey raster with white line at top	R815 22r in 16v supply o/c as c712 4µ7 hi esr also c811 220µ hi esr (16v supply line had risen to 29v)
BEKO	11221T	Dead	Psu working - no line drive - line dr tfmr
BEKO	11214T	Int no pic - sound ok	T701 thy esm740 goes o/c int - nla -- use a tr03-400t & add 47r ½w resistor from gate to ground
BEKO	11214T	Int no picture - sound ok	Thyristor t701 esm740 goes o/c intermittently esm740 no longer available, use tr03-400t and add a 47Ω 0.5w resistor from gate to ground.
BEKO	30320	Pic int fades out	Invisible dry joint on loptx pin (crt htrs)
BEKO	28128	Dead	Chopper trfmr shorted - found aft many k2545's later