Cce Repair Tips
Search: cce
Results: 4824
Results: 4824
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| CCE |
HPS 2971
|
The power supply turns on, but when turned on it has a horizontal line at the top. | C 901 | Replace without testing. (it's worth it) | |
| CCE |
HPS2092
|
This TV had a phase error, there was a stripe on the right side of the screen. | Analyzing the schematic I saw that c 401 and c403 were responsible for the horizontal phase, I tested it on the capacitor they were ok. | In my case, the solution was to replace the two capacitors without testing, c401 and 403 remained file. | chines eletronica |
| CCE E PHILIPS |
HPS , PT E FWM
|
TVs that turn on and off all the time, or take a long time to turn on, when changing bcs 337 and 327, replace them with bd135 and 136, only respecting the correct position of the pins | It won't come back with this defect. | Help yourself, post your tips here. | ÁdrianChapadãodoCéu |
| CCE |
HPS-2071
|
Not working | This TV was not turning on nor did the LED light up, I touched up several solders and it was found that the q810 (bc337-25) had the hfe between the base and the collector very high. | The replace of the same | Hipereletronica service (MARCELO) |
| CCE |
TV2118USP/AV
|
It starts, the LED flashes but goes into protection | Check d=831 short | I replaced it and plz | ELETRONICA MEDEIROS |
| CCE |
HPS2980
|
Retrace lines appear on the screen after a while on, wanting to close the vertical. | Change vertical ci | Diego PG-PR | |
| CCE |
HPS 2071
|
It turns on with the vertical closed and then goes into standby. | Q804/bc337. | edsomvideo | |
| CCE |
HPS2002
|
Sawtooth (looked like a high voltage leak, it was so small) | Ic 801 - uc3842b | Alextecnico | |
| CCE |
HPS2071
|
When the image appears, the LED flashes quickly and the TV turns off | Micro | Replace the microcontroller, | Roberto Consertos |
| CCE |
TV29USP
|
Screen like guitar | Q406 with cold welding | Resolder | EletroClaudio Aguas Belas |
| CCE |
HPS21AUP-HPS2071-2073
|
Image shifted horizontally (centering) | Defective capacitor c417 (330pf/1kv) | Replace | jasvan souza |
| CCE |
HPS2991
|
Turning off by itself | Resolder the smd resistors for the flyback r 417,418,414,415 | Ok | ELETRONICA MAURI JUNIOR |
| CCE |
HPS2198
|
As if the volume key - had always been pressed, volume was always at minimum | Chave on off | Replace key on off | Raulino |
| CCE |
HPS1420
|
The TV does not turn on the LED does not blink or blinks and goes out | Remove the horizontal transistor and check if current is coming in, if it does, just change the transistor | deive | |
| CCE |
TV2118USP/AV
SL23-1 |
TV with blinking LED missing the +b | Loose diode position d 808 | Was resolved | JAILSON P. JESUS feira de santana- bahia |
| CCE |
TV218USP/AV
SL23-1 |
TV with LED blinking and no voltage +b diode position d808 loose | Cold soldering | JAILSON P. JESUS feira de santana- bahia | |
| CCE |
HPS21AVP
H2197A |
8cm wide bar on the right side with image doubling | Transistor q-401 (mpsa42) | Preferably replace for a silver mascara | Abacuque |
| CCE |
HPS-2171FS
|
Low power supply with blinking LED | Short on the 16v line, ic601 showing very low resistance from pin 7 to ground. | Replace ic601 tda1517 | EDSON DE SOUZA AGUIAR |
| CCE |
HPS-1471
|
Turning off after turning on | Q802 = bc337, replacement of the same | Hipereletronica service (MARCELO) | |
| CCE |
HPS-1418USP
|
Doesn't start. | Fotoacoplador e ic tl-431 | FERNANDO S |