Cce Repair Tips
Search: cce
Results: 4824
Results: 4824
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
CCE |
HPS-1418USP
|
Fotoacoplador e ic tl-431 | FERNANDO S | ||
CCE |
HPS-2071
|
Image flashing when the image changes | C. 417 | Replace the same and go out for the hug | Dan levita |
CCE |
TV 21USP
|
Image without contrast and with retraces | Resistor,open, on the kinescope board | Replace fr901 | |
CCE |
HPS 2990
|
Very poor images and sound | If bloco do if perto do varicap | Of the resoldier's day | antonio dos santos lima |
CCE |
HPS1473
|
Does not turn on, the LED blinks and does not turn on, adjusting the scrin turns on with the vertical closed and turns off continuously | Q 802 bc337 pifado | Replace bc 337 without midir | celito santo angelo |
CCE |
HPS-29AVP
|
Red image | D902 with leak | Just replace it for the new one | neto wolff ribamar.ma. |
CCE |
HPS-2971
|
When you turn on the LED goes off as if it were going to turn on, but there is no image | Capacitor c-869 2200 x 25v swollen and capacitor c-409 560n x 400v altered | I just replaced it and it was ok, I replaced all the 337 bc's preventively | Fábio Andrade |
CCE |
TV2118 USP
|
Blinking led | C 831 of 1000x16 sold out | Alvanyr |
|
CCE |
HPS1471
|
Turns on and then turns off | Dz807 8v2 shorted | Osmildo J Silva Nova Lacerda MT | |
CCE |
HPS-2002-2003-2004
|
TV does not turn on with all normal voltage only the stanby led is off @@@ | L703=47r open power supply to ic 701 pin 2 | ELETRONICA ARNI-SC / LEOBERTO LEAL | |
CCE |
HPS 2118USP/AV
|
Low power supply and not part | Photo coupler and tl 431 | I replaced them both and it was ok | FERNANDO |
CCE |
HPS-2997-F
|
The device shows three lines, green, blue and red, in the upper part of the kinescope, both, in a vertical direction | Polyester capacitor, 394 k, on the board, it's c-409, close to the horizontal circuit, replace it, it's ok. | TECNOSAT ELETRÔNICA E INFOMÁTICA, JATAÍ-GO, |
|
CCE |
HPS-2991
|
There is no +b low power supply with 15v | C816 470uf x400 defective | To replace | joao paulo |
CCE |
HP-2065F
XX |
Doesn't start | Zero power supply does not oscillate in the primary | Resitor r802 470k 1/4wat | antonio dos santos lima |
CCE |
HPS-2991P
|
Doesn't start | C406 ceramic shorted @@@ | ELETRONICA ARNI-SC / LEOBERTO LEAL | |
CCE |
HPS1402
HPS1402 |
Burning horizontal outlet | Capacitor jc16 10uf 16v is placed in the placeper | adao | |
CCE |
HPS2991
|
Power supply does not work, led is off, 18v missing from zener dz801 | Cause: defective photo coupler | klein | |
CCE |
HPS-21AVP
|
Closing the side of the image | C417 close to the flay back | Replace value:331 2kv | Ohm eletronica, |
CCE |
HPS-1471
|
I didn't tune in, I only got channel 2 | R109 12k open | Replace r109 12k | beto2828 |
CCE |
TV-29USP
|
Image shrunken horizontally, in reel format (without pincoushin) | R 852: 100Ω toast, and q407: bc848b (smd) leaky | jasvan souza |