Cce Repair Tips
Search: cce
Results: 4816
Results: 4816
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| CCE |
HPS 2997FS
|
Sometimes there is no brightness or sound, normal power supply voltages, filament lit | Screen with only 420v | Replace c901 on tube plate | jasvan souza |
| CCE |
HPS2985
|
Blurred image with black stripe on both sides of the screen | Defect and resistance 423 1k open | Replace the same | brancobilli |
| CCE |
HPS2997 FS
|
TV stopped, not even the LED lights up, the power supply only has the primary one. | Shorted flay-back, completely killing the secondary supply voltages. | The flay-back was replaced and it was ok... | Armando de Olimpia |
| CCE |
TV-29USP
|
Turns it on and off, no image appears | C 402 | eletronica rodrigo 048 32429465 | |
| CCE |
HPS-1497
|
Help to be helped. nothing works, except the secondary power supply normal voltage. | Help to be helped. | Replace the d814 diodes and the d2808 zener. | LOU |
| CCE |
HPS1471FS
|
High power supply giving 200v | Open 113k r816 | zezinho | |
| CCE |
2198
|
Turns off | As micro chave do ch | tec center | |
| CCE |
TV 2118 USP/AV
|
Image shifted to the right side with hashing | C 417 | Replace directly without measuring | DIGITEC ELETRONICA (65)9608-4535 |
| CCE |
HPS1471
|
Does not tune the channels | Fellata + pardon | Check r106,107,108,109 | gilson |
| CCE |
HPS 2997
|
Lights filament with no image and no sound | Circuito abl r423 e c421 | DIGITLA TEC ELETRONICA | |
| CCE |
1471 I
|
Noise in the image and sound a/v works normally | Smd capacitor c 102 connected to pin 35 of the tda | Replaced after a good thing. | Márcio Ramalho |
| CCE |
HPS1402
|
Turns on and then turns off | Replace the q802-bc337 with a new one and see you later, | Paulo Sertel Itararé SP | |
| CCE |
HPS-2997
|
No sound on tv, but there is sound on av | No sound on tv, but av has sound | Enter service mode, go to inb, reset the TV, and the sound comes on... | house eletronica ltda |
| CCE |
HPS 3407 FS
|
Normal turns on, lights filament but no video | C 409 | Beto Eletronica Acrelandia AC | |
| CCE |
HPS2171
|
Does not turn on relay | Changed screen setting | Lower screen | Fabio |
| CCE |
HPS 21AVP
H-2197A |
It doesn't work, but the LED lights up, normal power supply. | Flyback bsc25-0206h shorted | Changing the flyback, but at the moment I didn't have it, I replaced it with the bsc25-0210f, but there was a strip on the right side, so I replaced the 12kv wide c 418 cap with a 15kv one and it worked normally. | jose dacio |
| CCE |
HPS2991FS
|
TV turns on, off and on and off, R822 heating up a lot | C740 smd with fault, no use testing | To see if he can eliminate the c740 himself to see if the r822 stops heating, if so and just add another good luck | EVALDO GOMES |
| CCE |
29USP OU 2910FS
|
Image shifted from left to right | C402 of 330pfx2kv this one was measuring 50pf, just put a new one and that's it | saulo figueiredo | |
| CCE |
HPS-2002
|
Turns on when it wants, stand by LED goes out but does not oscillate | Bad 9v supply | Replace q802, there is no point in measuring, and cold solder the smd resistor that goes to the base of this transistor. | MARCELO QUINELATTO |
| CCE |
HPS 21AVP
|
Screen shifted to/right | C-417 proximo ao flay- back , 330pf/ 2kv , azul. | joelton |