Cce Repair Tips
Search: cce
Results: 4816
Results: 4816
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| CCE |
HPS 1402 E
|
TV on stand-by +b ok, with whistle and when it turns on the whistle increases, but the TV doesn't turn on | C825 (electrolytic capacitor 47µf x 160v) auterated, without capacitance | Replace it, and then only joy | Marcos |
| CCE |
HPS 2002D
|
Vertical with light stripe in the middle. no image from the middle to the top. diode d301 almost open. | D301 1n4004 | Replace with any 400v 1a or higher diode. | Tecvideo |
| CCE |
HPS 2004
|
Replace it | Electrolytic capacitor c812 | Replace it | Amauri center som |
| CCE |
HPS 2971
|
Very squeaky noise in the tsh. | Tsh and ci. tda 8359j broken. | They were all replaced and everything went back to normal. | JOSIAS ELETRONICA |
| CCE |
HPS2981
|
Does not work with remote control | C.730 short ceramic | julio itaguai | |
| TV. CCE |
HPS 2171 FS
BOA11IF.GTN20D3FD |
TV turns on and off. you can see image side stripes ld flashing tv | In this case, you will notice that the power supply is low. TV turns on and off seeing horizontal bands on both sides. | I replaced the c 825 47 / 160. It was already full sunday afternoon. This is crazy stμFf... | jaironuness |
| CCE |
HPS2991FS
|
Screen would go white with lines or black screen then it would turn off sometimes I would hear a few clicks | Tube socket, change or remove the spark gap ground shield | elder | |
| CCE |
HPS2171FS
|
Turned off | Shorted power supply | Fet-ci da fonte+ fusevel | elder |
| CCE |
HPS 2071
|
No image but with normal color and sound | Fro (fusiresistor)403 open, close to the fly back | Gilconceição | |
| CCE |
HPS-2185FS
|
Doesn't start | There is no +b 118v, pin 8 sec.transf, cause c825(47uf/160v), it was a little swollen, insulation defect! | Replace it ok! | Luir |
| CCE |
HPS2991
|
Works for 30 seconds and turns off | Leaky transistor 802 and 805 | Replace the 2 transistors | eletronica pedsom |
| CCE |
HPS1490C/D
|
Reduced screen | C320 | TED | |
| CCE |
HPS1471
|
When you plug it into a socket, the LED lights up and turns on normally, and when you unplug it again, the LED no longer lights up, and sometimes it just blinks. | Change the 18v zener diode dz801, even though you are measuring exactly | EDILSON | |
| CCE |
HPS 1473
|
Power on stand flashes and does not turn on at high voltage | Swap q802 and 804, testing the transistors it seems good | You have to replace it ok | LUIZTVSOM |
| CCE |
HPS 2185FS
|
Inoperante.com the good fuse is the resistor fr 804 of 2k2 toasted I changed it.it burned again. | Ic 801 short | Replace ic 801 is fr 804 of 2k2. | |
| CCE |
HPS 2081
|
Burning horizontal dyive transistor q401 c2236 | Resistor 402 changed to + the value of r and 39 homs was measuring 59 homs, heating the q401 to 2236, just run for a hug. | fernandoferreira | |
| CCE |
HPS
|
TV keeps changing channels by itself | 1 m resistor changed | Replace everything within 1m that is close to the memory that controls volume, brightness, channels, tuning and other functions when you are sure that the memory is good | andrew |
| CCE |
HPS 2997 S
|
League is high but without image and audio | C 901 with trc plate | Edson Peixoto | |
| CCE |
HPS14RD
|
Low power supply in the secondary | Change the r828 of 4k7 | tony eletronica | |
| CCE |
HPS 1470Z
|
Does not tune channels | R707 47k open | Resistor replacement and AGC adjustment | junior |