Cce Repair Tips
Search: cce
Results: 4816
Results: 4816
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
CCE |
HPS2007 E
|
The image disappears and it appears to be without an antenna but then it comes back with no antenna signal | 5 volts missing from varicap change dz102, q101 | fabiusmax | |
CCE |
HPS-2185FS
|
+ b does not stabilize | This television on standby would have the +b between 80vdc and 130vdc, the correct one being around 103vdc, and when I turn on the power button, it oscillates between 100vdc and 200vdc, correct 118vdc. | Dz811 diode 10v short, after the replace it returned to normal +b | jair.com2008 |
CCE |
HPS 20
|
It turns on for a short time and turns off. If it has 5.1 v or more it won't turn on | Tem ci 7805 | Joel justo | |
CCE |
HPS 2003
|
Normal image and with characters running | R:741 open smd on the osd line | Alvanyr |
|
CCE |
HPS 2185
|
With audio at the output, but there was no sound. | Ic 603, after the exchange it worked normally. | Léo, Natal-RN | |
CCE |
HPS-2991
|
Doesn't start | Capacitor eletrolitico c-825 100/160v | ladmyr/ bh | |
CCE |
HPS2991
|
Horizontal risk, closed horizontal. | C-409 390k 250v aberto | ||
CCE |
HPS 2781
|
Burning bu2520 | C404 chap. 13k/1600 polyester with low capacitance | ||
CCE |
HPS1405H
|
No picture, normal sound | C 410 cer. 101k with leakage, it worked as a resistance | cdvair | |
CCE |
HPS2991 FS
|
The image is expanded vertically, appearing as if it were retrace lines | 150r resistor (r310) open | Marcos.Vale | |
CCE |
TVD 2911
|
Turning off by itself right after turning on | Defective horizontal protection | ''bc 337'' q802 / q805 (direct replacement without measuring) | cesar_unitec |
CCE |
HPS-1403B
|
Rainbow effect | +b -b vertical ok | Vertical ci replace | jair.com2008 |
CCE |
HPS2004
|
Power supply sometimes arm or stays low blinking the led when releasing the pin but the power supply goes up | Defect; c812 at power supply | ||
CCE |
HPS 2997FS
....... |
TV doesn't start, it just stays on stand-by. | Does not oscillate. | Replace q802 and q805 = bc337 with a new one and c835 =47μF for 25v, and c835 is good to put at 63v. | Armando |
CCE |
HPS1402
|
There is no image | Def. c829 33uf 160v | ||
CCE |
HPS1402 E 2004
|
Doesn't start | Ci 802 tl431 | ELETRONICA ARNI- L. LEAL | |
CCE |
HPS1402
|
Doesn't start | B+ normal def. hour traffic. | ELETRONICA ARNI- L. LEAL | |
CCE |
HPS-2991
|
Bad image, popping sound | 1k r-423 open | ladmyr bh/mg | |
CCE |
HPS
|
Bad image, audio popping | R- 423 of 1k open | ladmyr bh/mg | |
CCE |
HPS2991
|
Turns on, after 1 minute turns off and then turns on, turns off again | Q-401 change without measuring | steve |