Cce Repair Tips
Search: cce
Results: 4824
Results: 4824
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| CCE |
HPS1404
|
The TV turns on, there is sound, but the tube filament is off, meaning there is no high voltage or plot, of course | Q401 open drayver transistor. Attention, check the resistance on the 22hms tube plate, which I also opened. good luck everyone. electronica silva wellington in Jardim das Oliveiras São Paulo | ||
| CCE |
HPS2071
|
Even when replaced, after a few hours of use, the TSH shorts out, taking the FR401 protection resistor with it. | Change c417 without testing (330pf-2kv) or 331 lsk | ZÉCA | |
| CCE |
HPS1477
|
Vertical closed and turning off appears to be a vertical output but it is not! | Q 802, bc 337 | DANIEL SOLÂNEA PB | |
| CCE |
HPS2185FS
|
When plugged into a socket, the stand-by LED normally turns on. When pressing the power key, it indicates no pulse in the power supply, turning it on and off alternately. | Check or change c 825, c829. | If there is overheating c 825. use two 100μF 160v caps connecting (-) with (-), and the two terminals (+) (+) on the board. | MANTENOPOLIS |
| CCE |
HPS2981C
|
Stop, horizontal output burnt, output burning without apparent cause. | Abl control with correction deficiency | D202, if it exists on the board, remove it, leave it without. | ars |
| CCE |
HPS 2199FS
|
TV turns on with image, but occasionally lines of retraces appear | 22r resistor changed on the ctr board | daf eletronico | |
| CCE |
HPS-2085
|
Very quiet sound, even with the volume turned up. | Causes ,c 603= 10nf of shorted disk. | It was replaced and the TV was... ok. | Armando |
| BLUESKY (CCE ) |
TV20 BLK
|
TV with dark bar on the side and colors varying between them | Change or simply remove the capacitor -c 827 | The problem will be resolved | otecnico |
| CCE |
HPS-2971
|
Turns off and the filament remains on without image | Replace kinescope board capacitor..c-901 | ||
| CCE |
HPS1403
HPS1403C |
As soon as you turn on the TV, there are three RGB lines, so the normal open vertical from half down has an image more than half up with retrace lines. | D301 change without testing it works well in the test | samuel leite | |
| CCE |
HPS-2071
13/09/09 |
Nothing worked completely inoperative | Ic 801 tea1533at da power supply | Claudio Eletronica | |
| CCE |
HPS 2991 FSC
|
It doesn't work, it shows 2 green and blue rectangular bars at the top center of the screen. | C 409 this is a very important component in the television in focus. | Conscerta | |
| CCE |
HPS1470T OU 2070
|
When selecting AV mode, the word VIDEO is displayed on the screen, but it remains on the channel, it does not switch. | Replace there tda8361 | MANTENOPOLIS | |
| CCE |
HPS142
|
Whistle at the power supply | Swap c808 | Resistronic.blogspot.com | |
| CCE |
HPS 2171 FS
|
Doesn't work, normal high power supply, no 5v on the computer. | Electrolytic capacitor c706 100ufx16v in short circuit. This capacitor is very common to short circuit. tip, the flyback of this TV is tat2104, but the bsc25-0206h works normally on it and on the hps2118. | WAGGUINHO | |
| CCE |
HPS 2971
HPS 2971 |
Frame varying in the image with more brightness | R435 4k7 smd aberto | Replace the same | ANTONIO NOBREGA(patos.pb) |
| CCE |
HPS1471 A
|
Strong audio noise at high brightness; economical mode is normal. | Micro ehto line, p. 34. causes poor filtering of the Hz pulse coming out of pin 3. solution: open jump jb2, using a 470k 1/8 resistor; exchange the 100k c 408 for a 220 k 400v one. | Luna | |
| CCE |
HPS2071
09/09/09 |
When turning on, the LED blinks but it cannot work. At 110v it still works, even though there is no width, but it turns off. | See dry c825 (47x160v) | MAIRES | |
| CCE |
HPS 2185 FS
|
No audio signal | C601 | Roberto Consertos | |
| CCE |
HPS 2185 FS
|
TV turns on with filament but no video | C 424 | Replace c 424 47kpf mo abl | Roberto Consertos |