Cce Repair Tips
Search: cce
Results: 4816
Results: 4816
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| CCE |
HPS2071
|
Does not turn on inoperative | 18v zener diode completely shorted | Replace the 18 v dz 801 and ok | eletronica nova |
| CCE |
HPS2005
|
Image with amplitude,+b with 80v | C829 with little capacitance | c@rlinhoselectro | |
| CCE |
2904
|
Blinking LED does not turn on | I changed r807 r814 r 845 and finally r 820 and that's it | eletronica nova | |
| TV CCE |
HPS2171FS
|
C825 electrolytic cap burst | T801 | Remove it from the pci and resolder the wires that go to the pins of the t801 frafo | ROCHONA |
| TV CCE |
HPS 2171FS
|
Heating up and bursting the electrolytic cap c829. | Trafo t 801, remove it from the chassis and resolder the wires that go to its pins. Note normal power supply voltages. | ROCHONA | |
| CCE |
HPS2185FS
|
Turning on and off | C 825 with cold welding | Resolder | |
| CCE |
HPS-2073
|
Didn't tune the channel, it appeared to be the electronic c | Q101 -bc337 | c@rlinhoselectro | |
| TV CCE |
HPS 2004
|
Tv doesn't work | Changed c-417 with leak | jaironuness | |
| CCE |
HPS 1401
|
Doesn't start. It has a power supply but it doesn't oscillate | Fly back tat 1409 and resolder in the deflection circuit region. | Tec Video | |
| CCE |
HPS-2971N
|
Doesn't start | Short in power supply | Q803 q801 r812 fr803 fr802 d816 d817 tea1507 | |
| CCE |
HPS 2997 FS
|
ONLY turn on standby, the +b has 20v to 40v | C825 de 100m / 160v | Can also be replaced for 220m / 160v | SAMUEL |
| CCE |
HPS1490E
|
Image repousse, resulting in horizontal synchronization defect. | C401=1uf per 100v, without capacity connected to pin 33 of the ci..la7680. | It was replaced and the TV was... ok. | Armando da Eletrônica só Tv. |
| CCE |
HPS1404
|
The TV turns on, there is sound, but the tube filament is off, meaning there is no high voltage or plot, of course | Q401 open drayver transistor. Attention, check the resistance on the 22hms tube plate, which I also opened. good luck everyone. electronica silva wellington in Jardim das Oliveiras São Paulo | ||
| CCE |
HPS2071
|
Even when replaced, after a few hours of use, the TSH shorts out, taking the FR401 protection resistor with it. | Change c417 without testing (330pf-2kv) or 331 lsk | ZÉCA | |
| CCE |
HPS1477
|
Vertical closed and turning off appears to be a vertical output but it is not! | Q 802, bc 337 | DANIEL SOLÂNEA PB | |
| CCE |
HPS2185FS
|
When plugged into a socket, the stand-by LED normally turns on. When pressing the power key, it indicates no pulse in the power supply, turning it on and off alternately. | Check or change c 825, c829. | If there is overheating c 825. use two 100μF 160v caps connecting (-) with (-), and the two terminals (+) (+) on the board. | MANTENOPOLIS |
| CCE |
HPS2981C
|
Stop, horizontal output burnt, output burning without apparent cause. | Abl control with correction deficiency | D202, if it exists on the board, remove it, leave it without. | ars |
| CCE |
HPS 2199FS
|
TV turns on with image, but occasionally lines of retraces appear | 22r resistor changed on the ctr board | daf eletronico | |
| CCE |
HPS-2085
|
Very quiet sound, even with the volume turned up. | Causes ,c 603= 10nf of shorted disk. | It was replaced and the TV was... ok. | Armando |
| BLUESKY (CCE ) |
TV20 BLK
|
TV with dark bar on the side and colors varying between them | Change or simply remove the capacitor -c 827 | The problem will be resolved | otecnico |