Cce Repair Tips
Search: cce
Results: 4816
Results: 4816
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| CCE |
HPS 2971
|
Dead, main power supplys ok. | L 708 open responsible for powering the memory | Measure voltage of 3.3v in the missing memory the TV does not turn on | DEBIQUE |
| CCE |
HPS-1401
|
It doesn't turn on, it has a power supply but it doesn't oscillate | 22Ω resistor fr-914 that is on the kinescope board | ladmyr bh/mg | |
| CCE |
HPS2171FS
|
When turned on, the image was oscillating between normal image and retraction lines | Fr901 22r changed | Fr901 22r replacement | jair.com2008 |
| CCE |
HPS2001
|
When cold, it turns on normally, if you unplug it and plug it back in, it won't turn on. | Due to leakage in this capacitor, the IC's power supply is insufficient. (measuring pin 1 voltage "normal 17v" below this value does not arm the IC) | C808 leaky (100k ceramic) | jgsj11 |
| CCE |
HPS2171FS
|
LED lit when +b 100v, when power was pressed it tried to turn on and the +b dropped to 70v and returned to stand bye. | By releasing the +b pin on the fly and pressing power, the +b goes to 118v. | Replace fly back | jair.com2008 |
| CCE |
HPS-1497
|
Em stand-by nao liga | Transistor 804 | fabiusmax | |
| CCE |
HPS2004D
|
It only has sound, no mat. When testing the 103v with the digital meter, it indicated ol, overvoltage | Capacitors c825 and c829 exhausted | ronaldosb | |
| CCE |
HPS-1407
|
The TV was dead and the standby light didn't even come on | When it was opened I saw the power supply fuse was blown, so I started checking the AC power supply and that's when I found a short circuit (d809). | I replaced the fuse and dido and turned on the TV.. then it blossomed like hell | |
| CCE |
HPS 2981
|
Vertical collapsed bottom of screen (4 fingers) | R 306 (47k) aberta | ESPER | |
| CCE |
HPS 29 E
|
No blue in color | Changed q- 561 open transistor | jaironuness | |
| CCE |
A650
|
When I was going to turn off the sound with the power button it locks the other functions and does not turn off. | This defect was in the mechanics of the tape that screwed up and seemed to be playing, that is, the tape switch b was on so the circuit locks, the other functions when turning off the sound with the power button, | Paulo Marciano De Jesus | |
| CCE |
HPS 2908
|
Mode service: pin 45 of the micro touches ground a few times | Tap the earth a few times until the characters appear | esdras feijo | |
| CCE |
HPS1405
|
With normal audio, there is no high voltage | Q401 mpsa42 shorted, r410 open (8k2) | ALEX LIMA | |
| CCE |
HPS 2185
|
Weapon and immediately afterwards (when the video appears) it disarms (turns off) and turns it back on again. | C825 (near the fly back) | Replace it and the Q804 to be sure. | Tec Vídeo |
| CCE |
HPS2005
|
Doesn't start | Flyback | Tat2012 as it didn't exist, replaced it with tat2011. replace the 12n capacitor c418 with 6n8. | eletronica fernandes |
| CCE |
HPS2991FS
|
Image greatly expanded vertically | 150r resistor (r310) open | Marcos.Val | |
| CCE |
HPS 1480
HPS1480 |
Dark screen normal sound | Resistor r427 (4k7) fully open (stays in the wiring that leaves the dop tsh) | Replace the resistor | Abacuque Martins Silva |
| CCE |
HPS 2001
|
Does not tune in to a single channel | R102/12k -open | DANIEL MARTINS | |
| CCE |
HPS 2908C
|
Complete leak in pacifier | Broken ferrite wire | dj carlinhos | |
| CCE |
HPS2971
|
Fly back tat2971 | In case of exchange replace | Install tat2909 It's the same | MAXWELL ELETRONICA |