Cce Repair Tips

Search: cce
Results: 4824

Make	Model	Symptom	Problem	Solution	By
CCE	HPS-2991FS	Stop - note: no starting voltage on pin 1 of ic 801 (tea 1507p) and consequently taking time to discharge the c 816 (470/385) be careful!!!!!	Cause: ic803 (coupler photo)	Replace it - good luck to forum friends	This email address is being protected from spambots. You need JavaScript enabled to view it.
CCE	HPS2002	No picture, normal sound	Q401 defective	Replace q401	Eletronica Staub
CCE	HPS2991 FS	Weak blinking LED, tic power supply, tic, low voltage, TV won't start.	Replace of q808, direct replace, bd846 (1a) replace of d819 1n4148.		joaomvjr
CCE	TVS 2910/FS	Cushion effect,	Replace (q406) 2sd1408 (q407) bc846, use bc548 and r-852 (100r)		Ademar Videira SC
CCE	HPS2185FS	Hitting the relay and the 103v box power supply. to 65v.	Replace (q807 smd) that works ok!!!		This email address is being protected from spambots. You need JavaScript enabled to view it.
CCE	HPS2981	TV doesn't turn on.	When trying to turn it on, it makes a kind of chirp, beep, beep, beep and it doesn't turn on, it causes c403=560uf in a short, close to the fly-back.	The capacitor was replaced and it looks great.	Armando de Olímpia Eletronica EvoluSom
CCE	HPS1497	Can't tune channel 5v missing on seletronic	C107 470x16v raw just change it!		orlando lott
CCE	TV2118USP	Horizontal black band about 5cm	C-417 331pf	Replace	LUCIANO
CCE	TV2118USP	Horizontal black band about 5cm	C-417 331pf	Replace	LUCIANO
CCE	USP2918 X201	Flashing light and knocking relay	Defective 24.576 oscillator crystal	Replace the same	ELETRONICA N.A
CCE	HPS2097C	Flickering image with side bands +b low in secondary	Difference in power supply components due to heating	Remove 1r resistor r813 and put a 0.39 1w one in its place, obviously with a good fet.	santana
CCE	HPS-1491	Color system deficiency	C-559,112	Replace replaced	LUCIANO
CCE	HPS-2998	Na falta do fly back bsc-0192f.	The same can be replaced by the hps-2971 tv fly back.	Just make a small replace, disconnect the brown wire that goes from the tube housing to the tube chassis and leave the wire that goes to the main board outside.	Ademar Videira SC
CCE	HPS 2185FS	LED flashing, eleven flashes to + nine flashes and returns to standbay	+ b capacitors; c825 and c829 completely sold out.	Replaced both, it was ok	MIRANDA
CCE	HPS 2185FS	LED flashing, eleven flashes to + nine flashes and returns to standbay	+ b capacitors; c825 and c829 completely sold out.
CCE	TV 2118 USP/ AV	Cushion effect image	D 409 shorted, r 428 120 k, put 100 k		Vanoil
CCE	HPS2991	When turned on tsound is no image, when adjusting the screen tsound is an image but with saturation, if it turns off when turned on again tsound is no image	Tente circuitar l400		preá-rs
CCE	HPS-21AVP	Volume locked at zero (0) same manual as with the remote control.	Change all (05) micro switches on the board controls.		Ademar Videira SC
CCE	21AVP	Starting and it keeps making a short noise on the fly back	Ic301 la78040b	And just replace it and that's it	BETO ELETRONICA ACRELANDIA ACRE
CCE	HPS 1471	Vertical closed with list down the middle wanting to turn on and off without image appearing	Fr 402		MARCIORV