Philco Repair Tips
Search: philco
Results: 4775
Results: 4775
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILCO |
TP-2921
|
Excess green color | Eprom reprogramming. and a correction: to enter the service mode of this TV, press menu on the control and on the panel at the same time and wait a few seconds. | FERNANDO | |
| PHILCO |
PCS2952
|
Vertical closed | Ic601-la7833/c610-100/63v/d703 e r720-1r | Replace mentioned items | eletronicaapolo |
| PHILCO |
TPF 2130 REAL FLAT
|
My TV had the LED on when I pressed the power button and it went into standby mode | I replaced IC 601 (STV 9302 a) and resoldered the 936 resistor which was with capacitor glue | TV operating normally, I want to thank everyone for the tip and good luck | Jorge Luiz |
| PHILCO |
TRANSGLOBE B 481
|
Low volume and noisy on all tracks | Transistor t 406 pb 6015 after changing all the electrolytics in the amplifier, and losing some cable wires, I took it out and tested it and it said it was good, I decided to change it, damn the old radio came back to life | Marcio | |
| PHILCO |
TP2054
|
Sound just squeaks like failing, | Replace o capacitor c402 smd | Resolved | |
| PHILCO |
PCM2046
|
Blinking led | Defect l701 open | jglopes | |
| PHILCO |
TP-2054
|
Dull | Capacitor c727 shorted | Replace the 100n capacitor c727 with 100v | somprimos eletronica |
| PHILCO |
PCS 2956
|
Doesn't start | Q 706 or q 707 | ITAN,PARELHAS RIO DE JANEIRO | |
| TV PHILCO |
PCS 2956
|
Low sound | Ci tda 8843 pin 15 shorted | Play tda 8843 | ITAN,PARELHAS ,RIO DE JANEIRO |
| PHILCO |
PCM2051
|
Turns on works normally, but when turned off it doesn't turn on again | C708 and c709 and to avoid return, replace c704 and c706 | José gusmão | |
| PHILCO |
2046
PCM |
Image comes and goes, standby blinking | R 713 open | Replace resistor with a new one | luiztvsom |
| PHILCO |
PCM2046
|
When it heats up it keeps turning on and off | Resistor 713 changed 100k | julio itaguai | |
| PHILCO |
PCM2046
|
Vertical closed | D302 shorted | ELETRONICA ATUALIZADA | |
| PHILCO |
TPF2130
|
Doesn't start | Dac.elet.de 2200/16v - s924 | Replace the same | eletronicaapolo |
| PHILCO |
PCM2044
|
Led screen with retrace line without/picture with/sound | Kinescope plate socket | Tsound is no point in testing, you have to replace | |
| PHILCO |
PCM2051
|
Dark screen with no sound and it kept making intermittent clicks | Cap 471n which is close to the horizontal outlet | In my case I resoldered the board and replaced the capacitor | serginhosond |
| PHILCO |
TPF 2140
|
Normal power supply, but when you turn on the by, it then turns off, that is, it does not start. | High voltage at + 180 that powers the rgb circuit. Turning off the resistor - r 725 that polarizes the PC's protection (3.3v), the TV works, but it came with a reduced frame. the voltage was 180v - it was 215v. causes the c715 of 6n8 1k6, changed to minus. | Replace the c 715 (6n8 1k6v) and run for the hug!!! | Luna |
| PHILCO |
TV2054
|
Out of tune | Tuner | Replace the tuner | eletronicaapolo |
| PHILCO |
PCM1444
|
Vertical semi open | It has lines and a mirror image at the top of the screen | Changing the vertical output ci tda3653b or 3653bq solves the problem | ffeet |
| PHILCO |
TPF 29S4F
|
After a lightning strike, the TV stopped on the +b line so it only has 12v instead of 122v | Ic 101 defective microprocessor | FLAVIO |