Philco Repair Tips
Search: philco
Results: 4811
Results: 4811
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILCO |
PCM2044
|
Without tuning in rf has av | R004 33k | Open resistor replace | eletronica matieski |
| PHILCO |
PCM2044
|
When turned on, the TV turned pink with retrace lines. And then it turned off and kept chirping at the power supply. | The tube socket was bad, sometimes it worked, sometimes it didn't | I replaced it and it was left | |
| PHILCO |
PC-2043
CPH-05 |
Verified,+b,micro and tda-8361,normal,does not oscillate horizontal.mat. | Horizontal drainer transistor, in the test it is normal, replace it with a c-2271 transistor it is ok. | CLÁUDIO RIBEIRO, TECNOSAT ELETRONICA, JATAÍ-GO. | |
| PHILCO |
TP-2010
|
Gun relay, disarms quickly for a few seconds. | Resolder, d-907, or check that it is not damaged. | CLAUDIO RIBEIRO - TECNOSAT ELETRONICA-JATAÍ-GO. | |
| PHILCO ITAUTEC |
PCM1451
|
TV turns on with excessive high voltage and then turns off | Open or adjacent 15k 542 resistor | Replace and don't forget to measure r941 and 943 | NIVALDO_TEC |
| PHILCO |
TPF-2140
|
No sound just squeaking | C 401 smd em baixo do ic 101 | Replace or remove | Alvaro |
| PHILCO |
TP 1452
|
I'm sound | Eprom, perhaps need for adjustments, vertical height | SYSTEM ELETRONICA JUNIOR | |
| PHILCO |
PCM 1446
|
The TV turns on but does not obey commands, whether on the control or keyboard | Check r147 . r148 . r149 next to the keyboard | ze nascimento | |
| TV PHILCO |
PVT1014
|
Image without blue in color | Changed the q- 806 | jaironuness | |
| PHILCO |
PCM- 1451
06 |
Blinking LED does not turn on | C 911 and c 913 with low capacitance causing oscillation in the power supply secondary, i.e. +b and b5 varying | Replace c911 and c 913 tv ok | George Pontes |
| PHILCO |
1443
|
LED flashing.vertical closed.horizontal shrunken | Ic701 killing 9 volts that goes to pin 10 of 8361.8360 | Replace ic 701 | ANTONIO NOBREGA(patos.pb) |
| PHILCO |
PCM2146
CPH 05 |
Inoperative, LED blinking | Replace d302 e micro tda8361 | Marcio | |
| PHILCO |
TPF2130
|
Does not generate, when the power key is pressed the LED goes off and then lights up | Replace ic 903 tl 431 | ||
| PHILCO |
PCS-2976S
|
Image flickers on the sides | Replacement of capacitors c934 and c933 | francion | |
| ITAUTEC PHILCO |
TP-2052
|
The LED only stayed on, and it didn't work. | R121- 1k ( aberto) | When turning on the device, it seemed that the power supply armed the LED stayed on but did not turn on the device, tsound is a lack of 8v voltage that powers the IC. oscillator o tda 8841 2y | spectroneletronica |
| PHILCO |
TP20V56
|
The TV doesn't go into normal standby mode, but when you press the power key, the LED goes off as if it were going to start and nothing, only the LED keeps blinking | Lack of -12v voltage on the power supply secondary | D 909a shorted, r 912 and r 910 open. When replacing the TV it worked normally. obs d 909a specific trigger diode | GEORGE PONTES |
| PHILCO |
TP2053
|
It takes time to turn on or does not turn on, all horizontal and power supply voltages are ok. | C715 (6n8 p/ 20" ou 5n6 p/ 14") | MACC | |
| PHILCO |
PT1453
|
It turned on and then turned off and the LED just kept blinking, you would have to remove the socket from the mains to get the same symptom again. | Resistor (120 k 1%) in position 919 was open when replacing problem solved | Rivaldo | |
| PHILCO |
TP2054
|
TV doesn't turn on but has 109v and doesn't oscillate horizontally | Short ci that regulates power supply but it was changed | adair | |
| PHILCO HITACHI |
PC1427U
|
Inoperable when turned on it just makes a noise and stops | Nao tem b+ def. flaybek | Help yourself leave your tip good luck ass: arni | ELETRONICA @RNI- LEOBERTO LEAL SC |