Sony Repair Tips
Search: sony
Results: 20100
Results: 20100
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SONY |
SPP170
|
Intermittent operation - change x201, p/n 1-577-300-21 | Customer complains line light intermittently goes on, andsometimes cannot make outgoing calls. unit wouldn't pass rx sinadtest on the schlumberger phone tester. unit would pass test if a jumperwire was connected to antenna pad on 905 board, making p | ||
SONY |
MZR2
|
Customer complains of insufficient headphone volume level | Customer complained of insufficient volume level fromheadphones. noticed that the customer had the avls (automatic volumelimiting system) switch on the headphone remote set to the on position. | ||
SONY |
MZR2
|
Unit makes a chirping noise (replace ic603) | Unit would make a chirping noise. | ||
SONY |
MZR2
|
No operation from batteries, display indicates low battery | The unit would not operate from aa batteries. the displayshowed a low battery condition. the customer complained that the unitdrained the batteries prematurely. | ||
SONY |
MZR2
|
Unit will not load disc fully | A disc could be inserted into the mechanism, but would notstay locked into the mechanism when you removed finger pressure from thedisc. | ||
SONY |
D33
|
Gear in kit breaks (use gear with p/n 3-334-089-01) | The gear included with kit p/n t-9985-489-1 breaks. part #3-334-089-01 is a gear from a wmf-41 which is identical in size and is aperfect fit. this gear is solid from the top of the teeth to the bottomand appears to be a tougher material. i have been u | ||
SONY |
SLVR5VC
|
No video output at rf and monitor out | Unit had video output for line out only. found open circuitbetween ic202/8 and cn201/a2. | ||
SONY |
SLV900HG
|
Unit won't turn on | Unit wouldn't turn on. | ||
SONY |
SLV900HF
|
Vertical jitter in playback | Picture exhibited vertical jitter in playback. the rfswitching point was observed to be, at times, in the vertical blankinginterval or at the top of the screen. | ||
SONY |
SLV900HF
|
No rewind | Unit would not rewind. | ||
SONY |
SLV750HF
|
Intrmtnt loss of signal--blue screen | Customer complained of blue screen and loss of tuner signal.servicer found video signal going up and down at pin 18 of tuner module. | ||
SONY |
SLV696HF
|
Back-up cap | On page 78 of s/m the block diagram indicates that the back-upcap is c906 and on page 79 it indicates that it is c904. | ||
SONY |
SLV696HF
|
C905, c912, c913, c914 c930 labeled wrong on s/m diagram | C905 and c930 are indicated as being .1f and .01frespectively, they are .1uf and .01uf. c912, 913 and 914 have a yinstead of uf after the values. | ||
SONY |
SLV595HF
|
No video | No video from tuner or playback. ic102 had no video out ofic. | ||
SONY |
SLV595HF
|
Back-up cap | On page 78 of s/m the block diagram indicates that the back-upcap is c906 and on page 79 it indicates that it is c904. | ||
SONY |
SLV595HF
|
C905, c912, c913, c914 c930 labeled wrong on s/m diagram | C905 and c930 are indicated as being .1f and .01frespectively, they are .1uf and .01uf. c912, 913 and 914 have a yinstead of uf after the values. | ||
SONY |
SLV585HF
|
Hi-speed rewind | All functions normal, except tape does not unload for hi-speedrewind. | ||
SONY |
SLV585HF
|
Intrmtnt drum speed runs away | Customer complained of occasional shut off. servicer foundthat drum servo would sometimes run away. he replaced servo ic, drive ic,pg amp ic, and entire drum motor assy., no help. swapping boards fromanother unit, he found rp-112 was the cause. | ||
SONY |
SLV585HF
|
No tuner | Unit wouldn't auto program channels. all channels would be erased. | ||
SONY |
SLV585HF
|
No hi fi on pb | When playing a stereo recorded tape, the stereo light wouldn'tlight. |