Sony Repair Tips
Search: sony
Results: 20077
Results: 20077
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
SPPA20
|
Memo rec button sticks | Memo rec button sticks when outer edges of the button isdepressed. | ||
| SONY |
ITA505
|
Wrong part - rv-501 | Rv501 should be 6 leads but when ordered under 1-238-818-11(page 42) getting wrong part there are only 4 leads. this part will notfit into pc board. -hq comments: kcps checked their stock and found that the correct partnumber is 1-223-171-11. | ||
| SONY |
ITA2500
|
Fpr p0772 pertains only to ita3000 | Error in fpr p0772. everything it says pertains to its sisterunit the ita3000 but does not apply to the ita2500. the ita2500 has nospeaker phone function or the necessary ic501 to support that function. itdoes have, though, on-hook dialing and a speaker | ||
| SONY |
CMH333
|
Adjustments high from factory - redo evr adjustments. | Tx mod, as well as wb peak+ and peak- are adjusted a littletoo high from the factory. | ||
| SONY |
CMH333
|
No power on battery/difficulty in replacing udc connector j1 | Unit won't power up on battery. battery switch was found bent,and therefore open when it should be closed. therefore unit thinks caradptor is plugged in, disconnecting the battery. however removing j1 isvery difficult because the pins are too close toget | ||
| SONY |
CMH333
|
Front cabinet cracked - replace front cabinet, p/n x33673621 | We can see from the outside a crack or break onto the frontcabinet. in the four locations where the screws are inserted from the rearcabinet onto the front cabinet, the screws go through the front cabinet.this causes the screws to strip out and will not | ||
| SONY |
GEN-AUD
|
No 80 pin ic remover & no part number | Video equipment now has 80 pin flat pack ic. | ||
| SONY |
MDPK5
|
Won't play disc. (intermittent problem) | Play a disc, spindle runs stop and the tray will come out. | ||
| SONY |
MDP605
|
Will not initialize | This unit would not initialize when turned on. the elevatormotor would move the elevator up and down and then jam in the downposition. all the other motors would intermittently jam also. | ||
| SONY |
MDP600
|
Door won't open | When unit cam in, the drawer would attempt to eject, but thedoor would not open. | ||
| SONY |
MDP600
|
Intermittent power turn on | Very intermittent problem that customer complains of.customer sent a tape showing the problem. he would hit the power buttonor disc open button. display would light up and flash for a couple ofseconds then turn off. | ||
| SONY |
MDP333
|
Sled motor keep running moving the fop inside | Sled keeps running as soon as power on. check the voltage #1(ic102) 15v, #3 (ic103) 8v and #18 19 (ic101)4v. which shows ic102 isdefective. | ||
| SONY |
MDP210
|
Distorted picture (tbc) | Unit would play with distorted b/w picture. cd's would playfine. followed ref and spindle fg signals and signal path throughtbc ic and found only unstable fg signals. | ||
| SONY |
TCWR535
|
No power - cnp702 unplugged | The connecting wires between the power switch board and themain board is unplugged at connector cnp702. these wires are also tieddown to the transformer board to hold them down. between where they aretied down to the transformer board and connector cnp | ||
| SONY |
TCK666ES
|
Will not play tape, pinch roller jammed - free pinch roller | Pinch roller lever jammed, keeping playback head down. whenplay key pressed, only fast forward or rewind possible. due to thatproblem, unit can not lift head playback up to position of play. | ||
| SONY |
TAE2000ESD
|
Buzz in audio from display | Asd has a customer that has a tae200esd that buzzes when thedisplay is on. if you turn it off buzz goes away. customer has unit sono tests have been made. have you had any complaints about this yet anddo you have any suggestions as to what we might do | ||
| SONY |
TAAX401
|
Doesn't remember last function. | Unit doesn't remember last function. power off, wait a fewseconds, power on, defaults to tuner mode. this seems to be normaloperation. is it? -hq comments: this unit should recall the last function selected.please check the ground of the pc boards t | ||
| SONY |
TAAX311
|
No power to tuner unit - lost 12v line system | R958 on main board open, causing loss of 12v throughsystem tuner. tuner unit will not display. (connector cn1 pin 3). | ||
| SONY |
TAAV531
|
Loud pop when unit turned on - replaced rear spkr relay | Loud pop when turned on. | ||
| SONY |
TAAV411
|
No dolby surround with non-sony vcrs - audio out of phase | Customer had jvc hifi vhs vcr and above sony amp. when playingback dolby movies, he had no sound in rear channels. servicer, ruckersradio & tv, found that two other jvc models and a fisher model had samesymptom. however, sony slv-585hf and sl-hf beta mo |