Sony Repair Tips
Search: sony
Results: 20077
Results: 20077
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
KV2790R
|
Intermittent start up, replaced c578 | Intermittently start. weak drive signal to the horizontaldriver (q551. | ||
| SONY |
KV2785R
|
No remote control function, replaced ic105 "a" board | No response to sircs command from remote control. signal lowat ic105/pin 58, but is good at the other end of resistor r214 inseries with the signal input to ic105/pin 58. a new ic corrected theproblem. -hq comments: ic-105 is the tuning control. | ||
| SONY |
KV20TS29
|
No sound on right channel vol. level not responding, ic-404 | Unit volume not respond fully and right /ch not responding. | ||
| SONY |
KV13TR28
|
Power,vol,and channel up do not respond, s001, s002, r093 | No power operation or channel up operation from front panel. volume bars respond from volume switch, but volume does not respond. | ||
| SONY |
KPR41EXR95
|
High pitch squeal, remounted/resoldered l805 on n board | High pitch squeal from the unit and very intermittent. | ||
| SONY |
KPR41EXR95
|
No picture high voltage ok, replaced c327 on the e1 board | No picture, no display, sound ok. | ||
| SONY |
KP53XBR25
|
Red lines through picture, replaced red crt | After about 10 min, red lines would appear in the picture after 20 min picture would be all red. | ||
| SONY |
KP53XBR25
|
Distorted circle in middle of screen, replaced green crt | A 6 diameter area in the middle of the screen was out offocus when brightness and picture controls are at maximum. using thecolor generator, circle would only show up when a green picture was used. | ||
| SONY |
KP46V15
|
Remote rmy-115 works intermittently, troubleshooting tips | Customer's complaint was that remote rmy-115 worksintermittently but servicer has not been able to verify. they replacedthe remote and ir receiver and customer is still complaining. any othercomplaints or ideas on what the cause might be? -hq commen | ||
| SONY |
GEN-TVP
|
General operational temperature range of security monitors | Temperature range: -10 to +40c humidity range: 65-30% altitude range: 600m | ||
| SONY |
FDLK400
|
No picture, replaced the lcd | No picture | ||
| SONY |
FDL380
|
Excessive brightness, replaced r345 | The brightness was excessive. | ||
| SONY |
FD525
|
Loose channel indicator plate, reglued plate | Channel indicator plate falls off. | ||
| SONY |
FD525
|
Loose handle, need samples | Pins holding the handle, fall out. the pins are not securedin the handles. | ||
| SONY |
FD510
|
No picture or sound, replaced c504 | No picture or sound. | ||
| SONY |
FD402A
|
Operational temperature range | What is the operational ranage of this product? temperature: -10 to +40 degrees c. storage temperature -20 to +50 degrees c. | ||
| SONY |
ANU1/ANU1A
|
Horizontal output transistor replacement instructions | When servicers order the orignal q503 the distributorssent them the correct replacement 8-729-016-32 as per servicebulletin tvp161r1. however, there are no instructions to change the baseresistor r523 at the same time. -hq comments: as you know we d | ||
| SONY |
SPPD15
|
No speaker phone - change c67, p/n 1-124-126-00 | H/s worked fine, but no audio in speaker or mic audio to lineduring speaker phone. i followed audio from the line to the speaker phoneic2/pin 27 and saw audio here. there was no output at ic2/pin 26. checkingthe voltages on ic2, i saw that most of the pi | ||
| SONY |
SPPA20
|
Icm recorded very low volume - ic-15 defective | When trying to playback icm's you couldn't hear them. theywere very faint. | ||
| SONY |
SPPA20
|
Loose battery cover base | Battery cover is loose, and in some cases battery cover willfall off with batteries installed. |