Sony Repair Tips
Search: sony
Results: 20077
Results: 20077
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
CDU31ALL/N
|
Error message when accessing the presidents disk | Unable to access the presidents cd rom disk. an errormessage appears please check your cd rom drive for the proper diskhowever, the correct disk is in the drive. all other programs work. -hq comments: i have experienced this problem. normally if you hi | ||
| SONY |
CDU31ALL/L
|
Error message when accessing the presidents disk | Unable to access the presidents cd rom disk. an errormessage appears please check your cd rom drive for the proper diskhowever, the correct disk is in the drive. all other programs work. -hq comments: i have experienced this problem. normally if you hi | ||
| SONY |
CDU7305
|
Error message when accessing the presidents disk | Unable to access the presidents cd rom disk. an errormessage appears please check your cd rom drive for the proper diskhowever, the correct disk is in the drive. all other programs work. -hq comments: i have experienced this problem. normally if you hi | ||
| SONY |
TCRX420
|
Display flashes and no functions - r731 open 1-219-136-11 | Display flashes and no functions. found r731 open. alsonoticed 3/4 volt spike at r731 and r730 during power on. this may causethe resistor to open after time. | ||
| SONY |
CDU31ALL
|
No eject, cold solder joint at power connector cnj201 | Busy led is constantly on cannot eject and motor spinningdisk. | ||
| SONY |
CDU31ALL
|
Error message when accessing the presidents disk | Unable to access the presidents cd rom disk. an errormessage appears please check your cd rom drive for the proper diskhowever, the correct disk is in the drive. all other programs work. -hq comments: i have experienced this problem. normally if you hi | ||
| SONY |
XRU660
|
Part # correction, ic702 (correct # is 8-759-509-91) | The part number in the service manual on page 71 for ic702 isincorrect. the manual lists the same number and description for ic701 andic702, but they are two different ics. | ||
| SONY |
CPD1604S
|
No picture/squealing sound (blows h-out with rgb plugged in) | |||
| SONY |
STRD790
|
Unit in protect - dolby bd and regulator bd unplugged | Unit in protection. 1.03v on outputs of front and rear amps. | ||
| SONY |
SLV595HF
|
Dead unit: replace c203in the power supply block | The unit was producing excess audio and video noise while inrecord mode. occasionally, the tape would spill when ejecting. touchingthe drum reduced the noise. later on, playback became noisy andfinally the power supply failed. | ||
| SONY |
CDXU400D
|
Skipping when vehicle makes turns (replace omd chassis assy) | The cd player would skip only when the car would go aroundturns. the problem is caused by wobbling of the spindle motor. | ||
| SONY |
CDXU500RF
|
Skipping when vehicle makes turns (replace omd chassis assy) | The cd player would skip only when the car would go aroundturns. the problem is caused by wobbling of the spindle motor. | ||
| SONY |
CDXU500
|
Skipping when vehicle makes turns (replace omd chassis assy) | The cd player would skip only when the car would go around turns. the problem is caused by wobbling of the spindle motor. | ||
| SONY |
CDXU300RF
|
Skipping when vehicle makes turns (replace omd chassis assy) | The cd player would skip only when the car would go around turns. the problem is caused by wobbling of the spindle motor. | ||
| SONY |
CDXA55
|
Skipping when vehicle makes turns (replace omd chassis assy) | The cd player would skip only when the car would go aroundturns. the problem is caused by wobbling of the spindle motor. | ||
| SONY |
CDXU300
|
Skipping when vehicle makes turns (replace omd chassis assy) | The cd player would skip only when the car would go aroundturns. the problem is caused by wobbling of the spindle motor. | ||
| SONY |
CDXU300
|
Random reading of disc t.o.c. (for identifying disc titles) | Unit controlled by xr-u330. whenever xr-u330 is switched fromcd to the radio (i.e., fm) the cdx-u300 will cycle through all 10positions of xa-10b before it stops (the radio plays during this period).this cycling will only happen one time unless either p | ||
| SONY |
CDPC87ES
|
No audio/no disc table rotation (replace r340, q-210) | The disc tray would not rotate. when you placed the discmanually into position, disc toc was read and the disc played but therewas no audio output. | ||
| SONY |
CDPC77ES
|
No audio/no disc table rotation (replace r340, q-210) | The disc tray would not rotate. when you placed the discmanually into position, disc toc was read and the disc played but therewas no audio output. | ||
| SONY |
XRU550
|
Part # correction, ic702 (correct # is 8-759-509-91) | The part number in the service manual on page 71 for ic702 isincorrect. the manual lists the same number and description for ic701 andic702, but they are two different ics. |