Sony Repair Tips
Search: sony
Results: 20100
Results: 20100
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
KV2680R
|
No sound or picture just snow, replace x-101 crystal | No sound or picture just snow. set could be turned on or offmanually, no other functions would work. remote control would not turnset on but all vip functions would work. sircs signal was present at pin31 of ic-103 but no clock or data transfer to ic- | ||
| SONY |
DT4
|
Part number for chucking plate not listed in s/m | The part number for the chucking plate located on theunderneath side of the lid is not listed in the service manual. the lidassembly ref. 110 does not contain the chucking plate. | ||
| SONY |
CDP291
|
Would not play disc | Cd would start to spin but would then spin backwards. | ||
| SONY |
CCDTR5
|
Noisy drum | This was taken out of a ccd-tr5 the drum is noisy. thoughtyou might be interested in the part. | ||
| SONY |
STRGX80ES
|
Unit is completely dead - no operation | The only indication of life on the unit is the volume controlled. nothing else works. there is a ground wire which is connected tothe frame behind the front panel. this wire lug is not flat against themetal frame and touches some pins on ic-301 (syste | ||
| SONY |
CCDF55
|
Evf part numbers | When replacing crt (1-546-085-11), listed on page 104, nopart number listed for the holder. used part numbers listed in ccd-f36supplement no. 3 manual:ring 3-724-570-01lock 3-724-549-01holder x-3724-509-1need all three when replacing the | ||
| SONY |
CDK006
|
Part number error in the service manual | The part number for ref. 510 cap, centering is erroneous inthe service manual. - hq comments: thanks for the info.tokyo fax (a910211): the correct part number is 4-915-217-01. | ||
| SONY |
KV19TS20
|
No color, replace ic-303 | No color. color hue, brightness, sharpness adjustments causeddisplay bar to change but no change in picture. no change in outputs ofic-303. data bus present. | ||
| SONY |
WMF2061
|
Incorrect part number for tape head | Part number shown on page 14 of service manual, ref. hp-901,is not correct for the head in this model. the part number listed is fora motor. -hq comments: the correct part number for the head is 1-543-705-11.thank you for bringing this error to our att | ||
| SONY |
MDP510
|
Will not play discs | Spindle motor will not turn focus error in on ps-193 ok. | ||
| SONY |
KV27XBR10
|
Picture blanks on in-active stations, replaced d-303 | Picture would blank if you tuned to an in-active station. | ||
| SONY |
KV27XBR15
|
Shutdown with crt connected | With crt connected set would shut down. with crt disconnectedset would operate. | ||
| SONY |
KV32XBR15
|
Audio balance was completely to the right, replaced ic-102 | When set turned on, audio balance always was completely to the right. reset balance and set was ok until power was turned off. the balance was always to right on turn on. | ||
| SONY |
ITK500
|
Radio audio on speakerphone | When you press the speakerphone, the radio audio wound bleeding. | ||
| SONY |
ITA600
|
Icm tapes being eaten and audio fluctuation on playback | Icm message tapes were being eaten and curled up on the top 1/4 of the tape. when it did play, the audio fluctuated. | ||
| SONY |
SPP80
|
No microphone audio from base when using speakerphone | Intermittent microphone audio output could be heard in handsetfrom base when using speakerphone by flexing pcb or hitting unit lightlyon top, but audio would soon be lost. | ||
| SONY |
ITA850
|
Intermittent icm will not operate - sometimes ogm won't | Reel sensor won't count intermittently, thus shutting down icmtape mostly but also sometimes the ogm. problem is during manufacturing.bracket (part no. 112) somehow was made that when ic pcb no. 906 fits intono. 112, there is space for movement between | ||
| SONY |
ITA750
|
Intermittent icm will not operate - sometimes ogm won't | Reel sensor won't count intermittently, thus shutting down icmtape mostly, but also sometimes the ogm. problem is during manufacturing.bracket (part no. 112) somehow was made that when ic pcb no. 906 fits intono. 112, there is space for movement between | ||
| SONY |
STRD2020
|
Major output failure - no operation | Both units have the same failure shorted q-702, 703, 704,705, 706, 707, 708, 709, 710. defective ic-701, and open f-902. alsoapplies to serial number 801035. have not been able to determine whychannels are being wiped. we have noted poor and open sol | ||
| SONY |
CDP470
|
Unit reads out no disc and stops playing | After playing a few discs, unit would read out no disc, cool-ing ic-4 brought back operation. |