Search: sony
Results: 20100
Make Model Symptom Problem Solution By
SONY CCDM8U
Part number for fp-10 flex connector S/m does not show p/n. please inform. -hq comments: p/n is a-7070-149-a.
SONY RS20
Missing p/n - flywheel Missing part number on page 28 ref #300. -hq comments: part number is a-3109-016-a. the reference number shouldbe #380. we will issue a service bulletin.
SONY KV1515
Tuner failure from static Two units with complaint of tuner failure with static dis-charge to front controls. -hq comments: please try the solution outlined in s/b 200r especiallyaffixing copper tape to the control panel assembly. this grounded tapewill act as a collector of st
SONY SLHF400
Fu-38 circuit board part number supplement 1 P/n a-6717-395-b in supp #1 subs to a-6717-395-a which is thefu-38 board for the sl-hf600. the sl-hf600 has some additional partsmounted on it and one interconnecting wire that should connect to cn305on the tm-82 circuit board, but will not because of t
SONY KV1882AEB
No video The unit had no video. sound worked fine. we found theproblem to be caused by d393 going leaky. this was preventing sufficientbias on pin 18 of ic301.
SONY CCDV8
No camera video No video in camera mode. one pulse missing from ic707.
SONY CCDV8AFU
Horizontal jitter during playback with vtr power on Unit would shutdown in rec mode when cam power was on, and inrec or pb mode when vtr + cam power was on. with only vtr power on, play-back picture had horizontal jitter.
SONY CDXR7
Sled intermittently will not move Intermittently the sled would not move from its innermostposition. when in the failed state the outputs q509-511 would get verywarm.
SONY KX2501A
No start up, replaced t653 Set would not start up. b + 320v, and 160v present on gaboard. troubleshooting showed only a negative going pulse to the base ofq652. also there was no pulse on the base of q651. located defectivet653.
SONY CDP302
Part number incorrect in s/m Part number listed in service manual on page 58 item 79 is4-308-840-00. this is the incorrect part number.
SONY SLHF900
Eats tape Very intermittently coming out of beta-scan, reel motor slow,but not capstan. results are tape damage since tu reel cannot wind itfast enough. -hq comments: problems of this nature are difficult to find. as wediscussed, if you send the unit to us we w
SONY CCDV8AFU
No camera video On cx23047b one pulse was missing. i think this is part ofmaster osc. giving color prob.
SONY SL2500
Part number for table assy (cap only) No part number for table assy - cap only - ref #705 (cap fort-reel table). -hq comments: this part is not available, nor is the reel table.
SONY BMC550
Missing part and part number Need p/n for four screws that fit into ref #374 on page 109.these screws are not shown in the pictorial. -hq comments: the part number for the screws is 7-685-862-09. forscrews bvtt 2.6 x 6.
SONY XR740
Wrong labelling of head pc board switches On page 41 of s/m for xr-740, 747r, 780 and 787r, thehead pc board switches are labelled incorrectly. your recent s/b #62 hasthem labelled incorrectly. the parts listing on page 41 also has themincorrectly. s701 is on page 41 of the manuals, but you h
SONY XR66
Reference number correction On page 38 of the service manual for xr-66, and on page 34 ofthe service manual for xr-80 the head pc board switches are labelledincorrectly in the parts breakout and listing below. -hq comments: we will issue a service bulletin.
SONY STRAV460
Volume changes are not linear Volume changes are erratic and jumpy when trying to changelevels with volume controls. tried changing ic601 to no avail. all otheroperations are ok. i have seen similar problems on model ta-ax520amplifiers also. this is a constant problem. -hq comme
SONY WMF1
Incorrect part number Part number listed in service manual is incorrect.
SONY WM8
Incorrect part number Part number listed for the p/b head in service manual isincorrect.
SONY STRAV560
Missing part number S/m does not list a part number for the front panel. -hq comments: part number for front panel is x-4906-723-1 for str-av560 x-4906-713-1 for str-av760