Search: toshiba
Results: 5617
Make Model Symptom Problem Solution By
TOSHIBA TS-213ST
Turns off by itself after a few minutes of operation.normal power supply. X401 503khz
TOSHIBA TS-218ST
Jagged image when turning on C408 de 10mf/16v
TOSHIBA TV1476
Vertical closed Cold solders on tda3653 pins
TOSHIBA M-5530M VCR
No image C310 of 470uf/16v
TOSHIBA M-X40M VCR
Pause mode, the image shakes beyond normal Rakhaa D A Sak
TOSHIBA M-X40M VCR
Play speed in ep and sp mode above normal R598 de 10k
TOSHIBA M-X40M VCR
Does not record, only plays R222 the 10k
TOSHIBA M-X40M VCR
Does not record audio, normal image R715 de 10k
TOSHIBA M-X40M VCR
Plays without color only NTSC tapes 10nf/50v capacitor CV19 on the decoder board (pin 03 of ICV04 TA7347)
TOSHIBA TV-2080
Reddish screen without contrast C511 10k/50v.
TOSHIBA TV-2080-E U5
Dead R802 de 330k
TOSHIBA CF20C40
Does not light Burnt standby power supply transformer.
TOSHIBA 2998ASU
Do not lower the volume under any circumstances (remote control and receiver)
TOSHIBA 2080 EAV
Vertical closed +b voltage is missing on pin 6 of ciq303, c323 leaky, broken q501, open r35 trimpot, or defective yock
TOSHIBA TV2987
Accidental switching from stby mode to service mode Open the stby circuit and enter service mode and reconfigure the eeprom addresses with the help of the service manual
TOSHIBA TV 2996S
TV makes noise from the speaker and takes a long time to turn on Replace do flay back
TOSHIBA TV 2996S
TV makes noise from the speaker and takes a long time to turn on Replace do flay back
TOSHIBA 1470E
No tension+b D821 it usually shorts out, it stays at the power supply.
TOSHIBA 1470E
+b with 65v more or less. D811, with leakage. obs``this tip works for the 2070 TV too.
TOSHIBA 1470E
With +b and it doesn't work. D826 with air which kills the 9v