Cce Repair Tips

Search: cce
Results: 4816

Make	Model	Symptom	Problem	Solution	By
CCE	HPS 2912	Dark screen	Eeprom memory	Replace and adjust brightness and contrast levels	ÁdrianChapadãodoCéu
CCE	HPS2971N	Dead, power supply in part	C806 / c855	Replace of the same	eletronicaapolo
CCE	HPS 2185 FS	Turns on after a few seconds turns off by itself	C 825 stewed	C 825 replace	Alexandre (Bolinha SRP4)
CCE	HPS1495	Without an image, only the characters appear, after a while or heating the plate the image returns.	C206 leaking on the board and causing leakage, close to the chroma loop		Bruske
TV CCE	HPS 1470Z E	Inoperative does not turn on	I did the research at the power supply and found the c554 ceramic capacitor 102k/2kv shorted or open	I replaced it and the TV worked ok	marcos jose
CCE	HPS 2971	Sem audio normal image	Broken micro	Cut jk2, place 22k ceramic capacitor between c 669 to pin 29 of ic603 (tda9855 2y)	Edson Caeté
CCE	HPS 2991	Doesn't start	C825 diminuindo +b p/ 70v	Just replace, send you the tips as well because they help	This email address is being protected from spambots. You need JavaScript enabled to view it.
CCE	HPS2071	Channels intermittently lost tune	C102 smd 100k	After a few minutes on, it started making noise and the channels were out of tune with a white screen	José Gusmão
CCE	HPS2071	TV inoperative, there is only voltage at the primary power supply	Dz 801, altered	Barter it	marcondes, jaicós-PI
CCE	HPS 1470	No rf signal	Missing 33 volts	12k resistor on the 33volt line	fofao
CCE	HPS2080	Heats horizontal outlet	Change c410 from 10pf/400v to 33pf/400v		This email address is being protected from spambots. You need JavaScript enabled to view it.
CCE	HPS1470		Auqecendo transistor saida horizontal	Replace the capacitor c410 from 10pf/400v to 47pf/4oov so the transistor stopped heating otv voltu nomal
CCE	HPS 1407	Has sound but no image	Flyback		Silva2
CCE	HPS 2971 HPS	Turn off the gun and disarm	I replaced the transistor q 802 and everything was normal	Thanks to a tip from my professional colleague	giovani pirata do sul
CCE	HPS.1407	Power supply changed 103v to 122v	Ic 803, photo coupler, dz805 4.7v	Concluded	E.MATOS R.S
TV CCE	HPS 2073 *	Turning off with retrace and white screen diode close to the flay back	D-sk4f1/06 na linha de 180v do flay back	Your replace	wagner
CCE	HPS 2118	Closing the sides	R 813 open 68k on primary +b high and low oscillating from 95 to 113 vlt		luiztvsom
CCE	HPS1471 A	Vertical closed n. good league gun prot	Ver q 802	Put on a new0javan
CCE	HPS2185	Closed image 4 fingers on top and bottom	R308 and r309 changed	Both should have 1.8Ω each and replaced to 4.4 after changing the screen normalized	José Gusmão
CCE	HPS2023D	Turning off intermittent	Q804 with leak		simas433