Cce Repair Tips

Search: cce
Results: 4824

Make	Model	Symptom	Problem	Solution	By
CCE	HPS-2004B	The LED lights up but the device does not turn on, the device's on/off switch does not work.	Without 8v power supply voltage and micro power pulse does not act on transistors q803 and q802.	Malfunction of the micro reset circuit due to cold soldering on the 3v6 dz-702 zener diode.	celinvds
CCE	HPS1497	Without oscillating horizontally.	C410 with leak	After replacing everything worked ok	DANIEL SOLANEA PB
CCE	HPS14RD	Does not turn on, has +b LED does not light up	D815	Shorted diode	matieski
CCE	HPS14RD	Reduced frame (bottom and side)	Ic 502 tda 8361	Replace	matieski
CCE	HPS2071	Turning off after a few minutes or not turning on at all	Replace the tr q802 and q804 with bd135 or bd139		CHARLES CIPRIANO
CCE	HPS-2092	TV when turned on, comes with 3 retest lines in the middle of the screen and then there are retrace lines at the top of the screen like if it were a bad capacitor	In fact, the resistance r308 of 100 r which takes 45 volts to the capacitor c310 which was burnt and the capacitor was not being powered, it was just a matter of changing it and it was gone.		This email address is being protected from spambots. You need JavaScript enabled to view it.
CCE	HPS2760	Burning the said horizontal and b.u	I changed the b.u and enabled it with kpf of 13 for 1500v	Just put the original	gabriel
CCE	HPS2760	Burning horizontal output and b.u 2520	I changed the b.u and enabled it with kpf of 13 for 1500v	Just put the original	gabriel
CCE	HPS1497/2097	The power supply doesn't even give a signal, the power supply's fet ic transistor is fine.	Defective ceramic capacitor c806 of 100nf 25v on pin 2 of the IC, with leak. I changed it and that's it.		rafael
CCE	HPS-2991FS	TV turns on and off quickly, sometimes it turns on and returns to STD by, or works normally	15 volt power supply keeps oscillating and makes noises in the power supply	Replace the dried out capacitor c825.	HOUSE ELETRONICA LTDA
TV CCE	HPS 2185	Blinking led	Tran. q802 e 803		central eletronica
CCE	HPS1470,2070 QUE USA O LA7680	No image appears in av	Check if the coil that is wound on the flyback has 2 volts or if it is inverted if it has 2 volts then invert it must have 12 volts on the d700 katode.		Sandro T Grachet.
CCE	HPS2070	Making noise on the flyback and in a short time the output burns out	I changed the x401 crystal and it resolved		Sandro T Grachet.
CCE	HPS2997	Turns off in seconds	Q802, put a bd135 in place.		Varela
CCE	HPS140	Does not tune the channel	33v ic101 short	Replace
CCE	HPS 2007C	Image shifted to the right	18k r414 open on hsyn horizontal sync line	Replaced the resistor and the problem was solved. Let's help the next one.	This email address is being protected from spambots. You need JavaScript enabled to view it.
CCE	HPS2007	Led standby piscando	Fr401 1r open horizontal feed		idasilvaj
CCE	HPS1471	Don't tune in	Q101	Replace q101	FABIANO 3553
CCE	HPS1403C	Doesn't start	Fr401 of 1r and c423 of 102k q402 bu2506dx short		AletroClaudiope Aguas Belas
CCE	HPS2071	White screen,return lines	Fr 901,on the plate of the trc	I agree	Manoel