Cce Repair Tips

Search: cce
Results: 4824

Make	Model	Symptom	Problem	Solution	By
CCE	HPS-2171FS	Turns on and the LED keeps flashing all the time and no image	After spending a long time on it, I noticed that when I opened the screen, 2 colored lines appeared in the middle of the screen horizontally.	Capacitor c416 close to the horizontal baffle connector	Jailson maia
CCE	LH42G	It turns on and then turns off, sometimes the image and turns off, it wasn't any of the memory.	Pci signal defect	Replace the signal board	ON-PLAY ELETRONICA
CCE	HPS-2198AV	Sometimes it calls	Change capacitor c808 on 22mfx50v power supply		ELETRONEUBERT
CCE	L244	Power LED does not light up	Q5 d476 ou d4186	Q5 d476 ou d4186	ASL ASSISTENCIA TÉCNICA TONINHO
CCE	HPS2971, HPS2985, HPS2991, HPS2997	Turns off as soon as it turns on.	Capacitor c831 (470mf 25v). (it is next to the large +b capacitor.)	Return tv. I had already checked and replaced a lot of things during the first repair. but that bastard escaped.	Eletrônica R-Tec
CCE	2118USP AV	Turns on and off entering protection	Cause and r534 100k open power supply with +b 180 v the right one and 115v just change		ELETRONICA FL
CCE UOCTOP	TV-2118USP/AV	LED flashing intermittently	C541	Replace without measuring the 220μF160v c541	Sinailson furtado
CCE	L244	Turn on STBY and then turn it off, sometimes you turn on the TV and no image appears, only lists	Ressolda na calm from power supply	Resolve and run for the hug	DIGITAL SYSTEM
CCE	D4201	The television turns on normally, the image turns off after a few moments (blacklight) leaving only the Audio.	The cause is two capacitors on the power supply PCI that were altered: c128 22x50v. ec20 100x25v.	Replace the two electrolytic capacitors	MACSOM MG
CCE	LT32G	Tsound is sound, no image, when turned on the LEDs blink	The voltage of the LEDs is below 54 volts	Test the LED power supply, if it is below 54 volts, replace the EC2 100x160v electrolytic for a new one and just be happy	Paulo Sertel-Itararé SP
CCE	TV21US	Turns on and off within a few seconds	Replace without measuring q802 q803 for bd135		DJ PITUKA
CCE	HPS-2171FS	LED flashing and no longer turns on b pulsing the bass	In my case it was the 2 caps of + b 33 and 47 uf 160v	Replace	eletronica sto ant rj bahia
CCE	TV2918USP/AV	Fly-back hole leaking high voltage	Fly-back	Replace the bsc29-0120k fly-back and the TV will work normally. God be praised!	Sinailson furtado
CCE	STILE D3201	TV with sound, screen lights up with no image	Open input fuse on the display strip and shorted ceramic capacitor.	Replace fuse fp1 and capacitor cp46	TIAGO
CCE	TV2118USP/AV FBT STD	This TV turns on normally, but if you turn it on the next day in the morning, it no longer turns on, nor does the stand bay light turn on anymore.	C829,c808	Replace the c829 of 33μF160v and c808 of 22μF 50v and the TV will work normally. God be praised!	Sinailson furtado
CCE	LN24G	Turns on, says "please wait", and that's it. it turns off, turns on, "for..." appears and stays like that all the time. The impression you get is that the flash memory is bad.	Check the "power" switch, it may be leaking.	Replace the "power" key.	arock
CCE	TV-2118USP/AV FBT STD	Expanded image	D409 eo q405	Replace d409 and q405 if you don't have transistor q405, replace this transistor with bf422. Put it the other way around and that's it, the TV will work normally. The BF422 Eli transistor is used in the RGB of Philips TVs. God be praised!	Sinailson furtado
CCE	HPS 1497	Side and focus bands	Shqqh	47µf / 160 v	Mastermil
CCE	1418USP	Turns on and off, LED lights up, turns off, relay hits	C417 shorted	Small darkened capacitor	Felixclank
CCE	LT29G	Turns on and the LED turns blue and does not turn on	Q10 (baw56 double diode, code in part a1	Place 2 in4148 diodes that works